Question about 2008 Ford Focus

Open Question

How to open deisel flap to put redex in

Want to put redex in tank but carnt open metal flap inside

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 119 Answers

SOURCE: put petrol into deisel tank

if you dont start engine drain fuel tank , if you started the engine clean the fuel filter.
after all that put diesel ,.

Posted on Oct 21, 2008

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gas tank will not fill up


The only thing in the way of a valve is the little flap that is about 3 inches or so inside the place where the lid screws on. Perhaps you could take a really strong flashlight and look and see if there is something blocking the pipe. Also, take a gas can for a lawn mower and put a small hose on the neck and try to feed a small hose down inside the tank and see if it will take gas that way. Watch out, though that the hose does not get caught by that afore-mentioned flap! You might take a long thin screwdriver or a heavy wire and see if you could hold that flap open.
Be blessed.

May 22, 2013 | Pontiac Sunfire Cars & Trucks

1 Answer

How to remove the fuel filler neck on my 1999 Dodge Grand Caravan 3.8 ltr. engine


OPEN GAS CAP FLAP THEN YOU NEED TO DRAIN GAS BELOW FILLER NECK.THEN LOOSEN REMOVE SCREWS IN THE GAS CAP FLAP AREA WHERE FILLER TUBE CONNECTS THEN GO UNDERNEATH VAN LOOSEN REMOVE HOSE CLAMPS AND REMOVE THE HOSE AT THE FILLER NECK BELOW THE GAS TANK.SPRAY WD40 AROUND HOSE AREA AT METAL FILLER TUBE STICK OUT GAS TANK.CAREFULLY USE LARGE PAIR OF CHANNEL LOCK PLIERS TO REMOVE WORK HOSE OFF METAL TUBE FROM GAS TANK. IF YOU CANT REMOVE HOSE WITH HANDS.BECAREFUL NOT TO MAKE ANY SPARKS.PLACE RAGS AROUND ANY METAL PARTS TO KEEP CHANNEL LOCKS FROM HITTING METAL MAKING SPARKS.

Jun 23, 2011 | 1999 Dodge Grand Caravan

1 Answer

Dodge dakota 2005 -check engine light(gas cap)gas cap was replaced.Fuel spills out when filling tank.Fuel lines were smoked and no clog was found.


There is a check valve in the filler hose to stop fuel from coming out seems yours might be stuck , run a metal coat hangers inside the filler neck while prying open the little fill flap. see if that helps OR you are not or have no VENT to AIR in your evap system causing excessive tank pressure.

Aug 28, 2010 | 2005 Dodge Dakota

1 Answer

When trying to put fuel in my car. my car whouldnt allow me to put fuel in it. it acted like it was full and ran out on the ground. what could be the problem? chevy malibu 1999


there is a metal flap inside that is spring loaded, make sure you are pushing the neck of the gas can (assuming you are using one) all the way in making the flap open up.

Jul 23, 2010 | 1999 Chevrolet Malibu

2 Answers

Carnt find diagnostic plug on car


see the headlight regulator on the driver's side. You'll then see a plastic Bolt. Turn 90 degree counter clockwise with a 2 Pence coin and open the Flap. Voilla the OBDII Plug is there.

May 11, 2009 | 2005 Peugeot 405

1 Answer

Filling up with fuel, pump shuts of continously...


hi if you look into filler pipe you will see a flap/restrictor just inside this is to prevent wron fuel filler nozzle from entering so unless you put the correct fuel nozzle fully into tank fill pipe and this pushes flap open you will experience slow filling ALSO? to put fuel in tank the air inside must be able to displace emit from tank ok this is done via a hose from tank and is usually clipped along side the filler pipe under wheel arch below filler check and ensure this pipe is clear and also free from kinks? as this if blocked will not allow displacement of air from tank as fuel level increases? hope this is clear enough for you to understand?

Dec 05, 2008 | 2001 Hyundai Santa Fe

4 Answers

When i go to put gas in my car it takes the gas and then clicks off the pump like its full so i have to wait like 30 seconds and put more in and keep doing these steps till its full...why does my tank not...


hi from uk are you putting the fuel pump gun/nozzle fully into tank filler? as there is a flap valve inside the tank filler neck and unless nozzle pushes this flap open it will restrict flow of fuel into tank one other cause of problem slow filling? is the ventilation pipe from the tank which is positiond along side of fill pipe ? may be kinked or blocked at outlet look under car where filler is and check? as fuel enters tank it displaces air from tank via this vent pipe? hope this helps you solve problem

Nov 04, 2008 | Hyundai Tiburon Cars & Trucks

2 Answers

Put petrol into deisel tank


take of the fuel sender hose of tank and be prepared to catch any spills wen finshed fill with deisel

Oct 21, 2008 | 2003 Ford Focus

Not finding what you are looking for?
2008 Ford Focus Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...