Question about 2008 Dodge Caliber

Open Question

Will 225/60/r17 fit on my 2008 dodge caliber i have 215/60/r17 on it

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 12 Answers

SOURCE: windshield wipers 2008 dodge caliber

Go take it to the dealer you should still have a full warranty. If you want to try and do it your self you could void that warranty.

Posted on Mar 12, 2009

  • 28 Answers

SOURCE: How do remove the rear lens cover on the tail

The lens covers dont come off. You can access the bulb from inside the trunk. By opening the panels

Posted on Feb 08, 2010

gordanddar
  • 477 Answers

SOURCE: Install A/C in an 2008 Dodge Caliber

You would be better off to sell yours and buy one with A/C . Retrofiting A/C into a car that did not come with it would be a huge job , lots of parts $$$$ and labour $$$$ Sorry

Posted on Feb 28, 2010

  • 12 Answers

SOURCE: how replace alternator dodge caliber 2008

there is a lengthy list on google of how to go about doing this.

Posted on Mar 11, 2010

  • 20 Answers

SOURCE: reset oil life moniter on 2008 dodge caliber

get in, close all doors, turn the key to run but dont start it... press the gas pedal all the way down and let it come all the way back up 4 times within 5 seconds.... DO NOT DISCONNECT BATTERY CABLES UNLESS ABSOUTLY NESSARY, cars today have so many sensitive computers in them that its not wise to do that unless all else fails

Posted on Jul 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a problemis with my dodge caliber 2009 the transmissoin dos not changing,


how to check dodge caliber cvt transmission ... - CarGurus

www.cargurus.com > Questions > Dodge > Caliber
CarGurusMar 20, 2010 - I bough used Dodge caliber SXT 2008 & i don't know how to check the CVT ... I have a 2009 300c and 2010 caliber and both tranmission are ...

Jul 20, 2015 | 2009 Dodge Caliber

1 Answer

Serpentine belt diagram for 2008 dodge caliber 4cyl


if the belt is still on the car take a picture to know the routing of it. there should be a decal under the hood somewhere that shows the belt routing.

Sep 16, 2014 | 2008 Dodge Caliber

1 Answer

2008 dodge caliber engine diagram


There is a Dodge website (not from the corporation, but from fans) for Dodge vehicles and they have a subsection on the Caliber. There is a 2007 or a 2008 service manual online there if you join their group. good luck.

Apr 05, 2014 | 2008 Dodge Caliber

1 Answer

2008 dodge caliber dash cluster "no fuse" ???


There is a fuse that the dealer has to install for the ECM. Make sure your ECM fuse is installed and not blown either.

Apr 10, 2013 | 2007 Dodge Caliber 2.0

3 Answers

Is it hard to replace alternator? I heard that you take right wheel off to get to it?


1. Disconnect and isolate negative battery cable at battery. 2. Remove the right front wheel. 3. Remove the underbody air dam.



4. Remove the accessory drive splash shield.



5. Remove the accessory drive idler pulley.



6. Loosen the lower mounting bolt.



7. Loosen the A/C compressor and relocate, pull down and to outboard side of vehicle to make room to remove generator.



8. Unplug field circuit from generator.



9. Remove the B+ terminal nut and wire.



10. Remove the upper mounting bolt. 11. Remove the generator lower mounting bolt.



12. Relocate the battery terminal (1) to the other side of the A/C line (2) for removal of the generator.



13. Rotate generator pulley down.



Dec 14, 2010 | 2008 Dodge Caliber

1 Answer

Install A/C in an 2008 Dodge Caliber


You would be better off to sell yours and buy one with A/C . Retrofiting A/C into a car that did not come with it would be a huge job , lots of parts $$$$ and labour $$$$ Sorry

Feb 28, 2010 | 2008 Dodge Caliber

1 Answer

Windshield wipers 2008 dodge caliber


Go take it to the dealer you should still have a full warranty. If you want to try and do it your self you could void that warranty.

Mar 12, 2009 | 2008 Dodge Caliber

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...