Question about 2001 Pontiac Montana

Open Question

How to replace starter on 2001 pontiac montana

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 55 Answers

SOURCE: replace thermostat 2003 pontiac montana

yes but with the right shaped wrenches and tiny hands it can be done without removing the exhaust crossover pipe

Posted on Oct 16, 2008

Ajkill
  • 2035 Answers

SOURCE: How do i replace the thermostat in a 2001 pontiac montana?

  1. Remove the air cleaner and duct assembly.
  2. Drain the coolant until the coolant level is below the thermostat.
  3. Remove the crossover exhaust pipe.
  4. Remove the radiator hose from the thermostat housing.
  5. Remove the thermostat housing bolts and clean any sealer from the bolt threads.
  6. Remove the thermostat housing and gasket.
  7. Remove the thermostat.
  8. Install the thermostat.
  9. Install the thermostat housing bolts and tighten them to 18 ft. lbs. (25 Nm).
  10. Install the radiator hose to the thermostat housing.
  11. Install the crossover exhaust pipe.
  12. Install the air cleaner and duct assembly.
  13. Good luck...
  14. Fill the cooling system.
  15. Install the thermostat housing and gasket.
  16. Clean the mating surfaces.

Posted on Jan 15, 2009

  • 2920 Answers

SOURCE: 2002 Pontiac Montana Thermostat replacement

check the coolant level fiirst...if that is low it wont give you any heat.....to change the thermostat you have to follow the top radiator hose to the engine.at the send of it you will see a clamp take it loose...then you will see the thermostat housing its held in place by 2 bolts . once you remove them you have the thermostat....make sure you clean all the old gasket material off both the housing and mount.also make sure you get a new gasket.

Posted on Jan 29, 2009

landsend
  • 1066 Answers

SOURCE: need to replace thermostat on pontiac montana van.

public library...Chilton or Haynes auto repair manuals or collisionrepairadvice.com     make sure you bleed the system

Posted on Apr 03, 2009

tse22
  • 103 Answers

SOURCE: Changing the starter solenoid on a 2000 Pontiac Montana

On your van the solenoid is attached to the starter. If you can get a solenoid separate (i don't know if you can) then you will need to take the starter off and remove the solenoid (2 screws holding it on) and the wires (on red and one black i believe) pay attention to which wire goes where because you don't want to reverse it on the new solenoid.

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 pontiac montana and am trying to figure out how to change the starter.


STARTER REPLACEMENT (ENGINE ELECTRICAL) Document ID# 688149 Starter Replacement

Removal Procedure

Important: This vehicle uses the PG260 F1 starter motor. The starter motor is serviced only as a complete unit.
  1. Disconnect the battery ground (negative) cable from the battery. Refer to Battery Negative Cable Disconnection and Connection.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.


  3. Remove the starter motor BAT terminal nut and electrical leads.
  4. Remove the starter motor S terminal nut and electrical lead.
  5. Remove the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.


  6. Remove the starter motor bolts.
  7. Remove the starter motor.

Installation Procedure



  1. Install the starter motor.
  2. Notice: Refer to Fastener Notice in Cautions and Notices.
  3. Install the starter motor bolts.Tighten:
    Tighten the starter motor bolts to 47 [n-m] (35 lb ft).
  4. Install the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle - 4T65-E.


  5. Install the starter motor S terminal electrical lead and nut. Tighten:
    Tighten the starter motor solenoid S terminal nut to 3 [n-m] (27 lb in).
  6. Install the starter motor BAT terminal electrical leads and nut. Tighten:
    Tighten the starter motor solenoid BAT terminal nut to 10 [n-m] (89 lb in).
  7. Lower the vehicle.
  8. Install the battery ground (negative) cable to the battery. Refer to Battery Negative Cable Disconnection and Connection.

Aug 05, 2016 | 2001 Pontiac Montana

1 Answer

How do you replace rear springs on a 2001 Pontiac Montana?


images for 2001 Pontiac Montana rear springs ..

Replace broken rear coil spring on pontiac montana - Fixya

www.fixya.com/cars/t3213136-replace_broken_rear_coil_spring_pontiac
Oct 17, 2009 - replace broken rear coil spring on pontiac montana - Pontiac 2000 ...Im having problems with my rear lighs on my 2001 pontiac montana, the ...

Sep 22, 2015 | 2001 Pontiac Montana

2 Answers

What size of starter for my 2001 pontiac montana?


The Montana only came with one engine size, unlike what others may think. Unfortunately, at the factory, two different starters were put in, one slightly larger than the other. I've run into this several times on the Montana. I'm not sure, but I think it has to do with whether or not your car has the heavy duty transmission(which is commonly(but not always) determined by your wheel base). The Montanas came in two different lengths.
I address it is by purchasing both, removing the old starter and matching it up to the new one, then return the one I don't use. I document it for my customer, that way they have a reference for the future.
if that isn't an option, then take the old one out, catch a ride to the auto parts store, and match it up there. That way, you are only out of pocket for one and you don't have to front for a core charge.
if that still isn't and option and you can get the car to start, drive it to the auto parts store, remove the starter in their parking lot, and match it up, then install your new one.

Mar 02, 2015 | 2001 Pontiac Montana

1 Answer

How to test or replace the ignition switch in 2001 Pontiac Montana


The last ignition switch I worked on was on a 1996 Pontiac sun fire. It was located on the left side of the steering column across from the key tumbler under the plastic. I found the start wires and jumpered them making the starter turn. Next I removed the switch from the column, and with a screwdriver, I turned it until the starter once again turned. I found the tumbler assembly wasn't turning far enough to start it. There was a small metal cover on the tumbler that had popped up and kept it from going farther. Hope this helps. There are some useful videos on YouTube that may help also.

Jan 29, 2015 | 2001 Pontiac Montana

1 Answer

How do i change the starter on my 2001 pontiac montana


Disconnect the positive battery cable, remove the wires from the starter solenoid, remove starter. I can usually sneak it out of there without removing to much of anything else.

Aug 08, 2014 | 2001 Pontiac Montana

1 Answer

Why my 2001 montana wont turn over


Do you have power to both posts on the starter ?

Jan 16, 2014 | 2001 Pontiac Montana

1 Answer

Need to replace starter


should be 2 bolts 15mm and then 2 nuts on the starter 13mm and 8mm. this is a very easy starter to do. make sure you remover ground battery cable before doing this starter.
good luck,
michael

Apr 29, 2009 | Pontiac Montana Cars & Trucks

1 Answer

Removing starter on2001 montana


if you can see the bolts it the three ones close to the starter besure to disconnect the negiative side of the battery before you start to take it off.

Feb 11, 2009 | 2001 Pontiac Montana

Not finding what you are looking for?
2001 Pontiac Montana Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...