Question about 1992 Buick Century
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: cant find the cam sensor
The camshaft sensor on this engine was located on the passenger side of the engine. You will need to remove the serpentine belt, and you can get to it by removing the inner fender or splash guard and get to it that way. I went down from the top. There are two sensors, one is a CRANKSHAFT sensor and other is a cam sensor. Make sure you know which is which. The crankshaft sensor is at the bottom of the engine, the camshaft is right by the water inlet. It is held in by 1 or 2 bolts. the camshaft sensor is not too hard to replace, it's tight but it can be done. unbolt the old and bolt in the new. Make sure you disconnect battery before tackling this project.
Posted on Aug 01, 2009
Check the number on the ECM . If it has the number 1228253 on it that is your problem. They had a cutting off problem while driving. Get one with the number 16198264 on it. The 1228253 is junk and gm replaced them with 16198264.
Posted on Nov 06, 2009
SOURCE: Where is the cam sensor located
I have the same auto and on that engine the is no cam sensor. There is however a crank positioning sensor. If you have any questions feel free to send an email and i can help you out
Posted on Dec 14, 2009
It is on the front of the motor just under the rear part of the waterpump in the timing cover. But I doubt it is the problem. Sounds more like a bad crank sensor. Which is located behind the crank pulley.
Posted on Jun 27, 2010
SOURCE: Find crank position sensor
The crankshaft position sensor should be located behind the vibration damper/harmonic balancer and it will have to be removed before the crankshaft position sensor can be replaced. (Let me know if you require assistance with the proceedure)
Also, it usually requires a special tool to align that sensor (available from most auto part stores) and if the sensor is not properly aligned then damage to the sensor or the tone ring can occur.
Here is an image of the crankshaft position sensor with the vibration damper/harmonic balancer removed.
Posted on Jul 11, 2010
Tips for a great answer:
Nov 07, 2016 | 2007 Chevrolet HHR
Apr 04, 2016 | Cars & Trucks
Jan 25, 2016 | 2008 Chevrolet Chevrolet HHR LT
Feb 16, 2015 | 2007 Chevrolet HHR Special Edition
Feb 16, 2015 | 2007 Chevrolet Chevrolet HHR LS
Feb 27, 2013 | 2002 Chevrolet Silverado 2500HD
Dec 06, 2012 | Cars & Trucks
Feb 18, 2011 | 2006 Chevrolet HHR
Dec 22, 2010 | 1999 Chevrolet K1500
Feb 10, 2017 | 1992 Buick Century
Sep 17, 2015 | 1992 Buick Century
141 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: