Question about 1994 Plymouth Voyager

1 Answer

Vibration during acceleration under load - 1994 Plymouth Voyager

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 104 Answers

Is it a 4x4 if it is then its the u joints in the drive shaft can also be the transfer case.if not check the engine mounts.

Posted on Dec 02, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 Chevy Impala 3.4L Base


were the motor & trans mounts checked?

May 26, 2017 | 2001 Chevrolet Impala

1 Answer

My 02 freelander vibrates when accelerated


A VIBRATION in the drivetrain is going to be noticeable both during acceleration and deceleration . Sounds like engine skip under a load.

Jul 17, 2017 | 2002 Land Rover Freelander

2 Answers

Vibration when accelerating and at high speeds


could be a few things engine mounts gearbox mounts cv joints on prop shaft flex disks if it has any could be missing when under heavy load there are many things i have somthing similer on my mercedes think its the flex disks hope this helps

Aug 18, 2012 | 2005 Ford Escape

2 Answers

Loud Vibration / Sound Under Acceleration And Starting Engine.


Get the engine mounts checked. A bad mount may allow part of the engine to lie on a body or frame part, allowing engine vibrations to become very loud. Torquing of the engine (under load) can cause the same type problems.

May 03, 2017 | 2005 Dodge Neon SE

1 Answer

1998 isuzu trooper vibration problem under load. Tires were just balanced and rotated. It has been getting worse over the last 2 months. New ujoints on the drive shaft. Still has a vibration when...


I would next check the condition of the engine, transmission and transfer case mounts. The mounts all have rubber inserts in them to absorb vibration and if the rubber starts to deteriorate or drycrack it can cause a vibration, especially under load.

Nov 22, 2009 | 1998 Isuzu Trooper

2 Answers

I have a 2003 Spyder, automatic with a 4 cyl engine. The steering wheel shakes at low speeds--below 30 mph, like a bent wheel, but it does not do it all the time or at higher speeds. Also, during moderate...


check your upper control arms, does it happen when you step on the brakes or just when driving, you might need a balance of all your wheels or the tires you have could be bad.

Oct 22, 2009 | 2003 Mitsubishi Eclipse Spyder

1 Answer

99 Lincoln Navigator


There are a couple of parts you can try and if they have not coded on the cars computer, a dealer may be able to look at service bulletins. There is a differential speed sensor and an antilock brake sensor. You can have locking clutch paks and may require a special additive. An old fashion U-joint can vibrate under load.

The good news is with a Vin# the dealer can pull up the entire service history if the car was serviced under warranty or in a Ford dealer anywhere. They just do not want you to know the past owner.

Jul 23, 2009 | 1999 Lincoln Navigator

1 Answer

Inordinant amount of vibration during acceleration


Clunking can be from c/v joints, hub bearing, lower ball joints or strut tower bearings, also from engine mounts (I know you checked but with a stickshift car it's difficult to load it properly without frying the clutch) Vibration likewise is difficult to find when it happens under load for same reason.A code check may or may not give you much to work with and O2 readouts often come from something other than an O2 sensor failure, rather from a failure upstream that sends the exhaust mixture beyond the sensors range.
It's impossible to make a diagnosis on these problems on-line because being there is important in doing this kind of diagnosis. I suggest you seek the opinion of a well trained experienced tech.who can actually be there to observe and test.

Jun 12, 2009 | 2001 Chevrolet Prizm

1 Answer

Vibration under passenger side floor board during acceleration


sounds like a bad cv joint to me. may need a halfshaft. check cv joint boots for being split open and leaking grease.

May 24, 2009 | 1995 Volkswagen Jetta

1 Answer

Intermttent vibration front end at high speeds


Vibration during acceleration is probably from axle going bad. Intermittent vibration at high speed could be a loose piece of plastic under the car or in the wheel well.

Aug 10, 2008 | 1992 Mazda MX-3

Not finding what you are looking for?
1994 Plymouth Voyager Logo

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...