Question about 1999 Ford Crown Victoria

1 Answer

Where is the ecm located on the 99 crown vic

We think the ECM needs replaced but can't seem to find the thing

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 129 Answers

It is under your dash behind the glove box. And close to the side of he car. It is right next to the computor. There is two silver boxes there and it will be the one that is next to your heater.

Posted on Dec 02, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
BPALepine
  • 61 Answers

SOURCE: locate fuel filter on 91 crown vic

The fuel filter is located under the vehicle on the inner side of the left (driver side) frame rail.

Should look like the image below:
a31eb6c.jpg

Posted on Apr 24, 2009

  • 5537 Answers

SOURCE: Wiper motor replacement for a 99 crown vic

I replaced the same part on a 1994 Crown Vic. There are a few bolts which go through rubber mounts on the firewall and that is how the wiper motor fits against the firewall. There is a clip on the wiper drive that must be pressed and slid off the wiper shaft. The hardest part was getting clearence between the engine and wiper motor. If I remember there was a way to turn the wiper case to clear the engine. I have asked myself why this was engineered like this? There is nothing important in the way that 3/4" of clearance could have been given for removal.

Posted on May 06, 2009

emissionwiz
  • 76691 Answers

SOURCE: where is the ECM located

On the 96 Se the computer should be located on the drivers side, behind the fuse panel. Remove the side interior panel, then loosen the bolts that hold the fuse panel so that you can get to the plastic box with a lot of wires hooked up to it. They are snap-fit connectors like the rest of them.

Posted on Jun 08, 2009

  • 111 Answers

SOURCE: 06 crown vic stalls out when full throttle

put these codes directly one at a time on google search and you will find the result

Posted on Sep 13, 2009

drsinister69
  • 2317 Answers

SOURCE: trying to locate spark plugs on 99 crown vic

They should be mounted down in the cylinder heads, you'll need to remove each coil pack. A long extension and 5/8in spark plug socket and an extendable magnet will help. Also, you may need to remove the fuel rail to get to move the coil packs.

Posted on Oct 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is theEMC on a 87 ltd 302 fi crown vic and what happens when it goes bad?


The ECM is located under the dashboard.
Try this before you replace the ECM change the pick up coil in the distributor the symptoms you are having usually happens when the pick up coil get hot and is defective. Here's how disconnect the battery, remove the distributor cap and you will see a disc like object below the rotor. It may have two or three screws holding it in place remove them and then remove the pick up cool. They start at $24.99

Nov 06, 2014 | 1987 Ford Crown Victoria

3 Answers

I took a 01 ford f 150 triton engine and put it in a 97 ford crown victoria and switched all the components over but it's not running right it stall on acceleration then pick up speed I did not switch the...


Yes. You need the ecu that came with that engine. Did you switch intakes? The f 150 4.6 has a taller intake and I believe the stroke is different. I would switch the throttle position sensor too.

Jul 31, 2014 | Cars & Trucks

1 Answer

Stalling


first scan for engine code.Codes P0600, P2105, P2107.
throttle body is common problem with ford
second connect fuel pressure gauge and drive
General Specifications
Item Specification Fuel tank capacity 71.9L (19 gal) Fuel Pressure Hot restart 448-482 kPa (65-70 psi) Key ON Engine OFF (KOEO) 140-415 kPa (20-60 psi) Key ON Engine Running (KOER) 170-280 kPa (25-40 psi)

Mar 23, 2014 | 2006 Ford Crown Victoria

1 Answer

99 crown vic police intersepter car will not run over 20 mph change coil packes and fuel injecters then fuel filter still didnt run right so then i change the cats and mufflers still nothing the only...


those cars are good for clogged catalytic converters . start the car and place a peice of paper over each tail pipe and see how much exhaust comes out. do not leave to paper there for long it will burn

Dec 04, 2012 | Ford Crown Victoria Cars & Trucks

1 Answer

I have a 99 crown vic and can't seem to find the


The car is designed not to spin it's wheels when taking off. If you want to make it do that you need to either change the powertrain programming or replace some powertrain parts.

May 07, 2012 | 1999 Ford Crown Victoria

1 Answer

How to fixaciggerate lighter in 99' ford crown vic


check the fuse first, then check the connections at the back of the lighter. very basic electrical circuit

Feb 02, 2012 | 1999 Ford Crown Victoria

2 Answers

I have a 1999 Ford Crown Victoria Police Interceptor with a bad transmission. Will any transmission from a 1999 or 2000 Crown Vic. or Grand Marquis work as a replacement?


MOST INTERCEPTER CARS, MEAN THEY HAVE AN ADDED GEAR IN THE TRANSMISSION! WHAT YOU'LL BE DOING IS GOING TO A TRANSMISSION WITHOUT THAT EXTRA GEAR! TO ANSWER YOUR QUESTION: YES YOU CAN REPLACE IT WITH A REGULAR TRANSMISSION! YOU JUST WON'T BE ABLE TO CHASE BURGLARS! HAHA

Mar 04, 2011 | 1999 Ford Crown Victoria

Not finding what you are looking for?
1999 Ford Crown Victoria Logo

306 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...