Question about 1989 Chrysler Fifth Avenue

Open Question

How to replace 1989 chrysler 5th ave ignition tumbler

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76691 Answers

SOURCE: Location of ignition control module on 85 Chrysler Fifth Ave.

it is on the firewall in most models, here is picture

d93987c.jpg

Posted on Oct 21, 2009

Ad
baccardo
  • 150 Answers

SOURCE: 1989 Chrysler 5th ave, shuts off when idling, hard to start,

sounds like a cooling system problem especially scince you mentioned the heater not working have the radiator and thermostat checked

Posted on Apr 16, 2009

  • 3 Answers

SOURCE: '87 chrysler 5th ave. running really rough

Had same problem with my grand cherokee,it was a loose ground wire, Hope this was helpful?

Posted on May 26, 2009

SOURCE: need to know location of fuse for

Well, i gotta tell ya.. i have the exact same issue. the odometer is the only thing ... well was... now the speedo wont register till i get down the road a ways.

Posted on Mar 26, 2010

  • 201 Answers

SOURCE: recliner?

The drivers seat reclines but it is electric, but the passengers side does too. The only problem is you have to do it yourself. Its not electrically powered.

Posted on Apr 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 5th avenue, idling problem


Stalls While Braked or Braking and While Turning.

www.2carpros.com/.../1989-chrysler-5th-avenue-stalls-while-braked-bra...
Jan 9, 2012 - 1989 Chrysler 5th Avenue • 89,000 miles ... Check the idle air control motor, EGR and PCV valves-also check the ... The 318s used in the Fifth Ave were built to really tight tolerances compared to those used in trucks and vans. ... and using a cardboard gauge to see if the floats fall down to the proper setting.

Sep 08, 2015 | Cars & Trucks

3 Answers

Fuel pump replacement 1991 chrysler 5th ave....? wheres the pump


Fuel pump on your car is in the fuel tank, fuel tank will have to be remove to replace fuel pump, don't forget to also replace your fuel filter.

Sep 08, 2010 | 1989 Chrysler Fifth Avenue

1 Answer

1988 5th ave a/c recharge/low preassure bypass switch


Even if there were a switch that you could jump ,running the ac with no coolant would do less for you then rolling down the windows.Also with no refrigerant in the system you would junk the ac pump in no time,not a good idea.Take it to an authorized ac shop to get it topped up and tested for leaks or learn to live without it.

Feb 15, 2010 | 1989 Chrysler Fifth Avenue

1 Answer

How do I loosen the tension of the pully to install serpintine belt on a 1992 chrysler 5th ave


Look for the tensioner assembly, it will be the one pulley on an arm, look at that arm, there will be a square drive hole in the arm, you should be able to put a 3/8" drive ratchet or breaker bar in that hole, then pull it the opposite direction of the belt. If there is no hole then use a wrench that fits the nut in the center of the tensioner pulley and again pull in the opposite direction of the belt. Remember to look at the routing carefully for installing the new belt. Hope this helps, let me know

Dec 10, 2009 | 1989 Chrysler Fifth Avenue

1 Answer

Ignition system fails. would like to convert from lean burn to basic electronic ignition


Mopar still offers the conversion kit, to swap out the lean burn to regular electronic ignition. I believe the kit is about $150. Has the vac advance dist,. ballast, and elec ign box along with all wiring and instructions... easy backyard/garage fix..couple hours...done... just did my 5th Ave last month.....works like a charm...

Dec 03, 2009 | 1987 Chrysler Fifth Avenue

2 Answers

I lost the keys to my 1986 chrysler 5th ave. If I


no the car is too old for chrysler to have records for your key code you will have to buy a new lock set unless you can get the old locks out and have a locksmith cut keys

Sep 27, 2009 | 1986 Chrysler Fifth Avenue

1 Answer

'87 chrysler 5th ave. running really rough


Had same problem with my grand cherokee,it was a loose ground wire, Hope this was helpful?

May 26, 2009 | 1987 Chrysler Fifth Avenue

3 Answers

1989 Chrysler 5th ave, shuts off when idling, hard to start,


remove the gas tank sending unit and replace it with a new one or new filter end and your problem wiill be solved

Apr 16, 2009 | 1989 Chrysler Fifth Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...