Question about Cars & Trucks

1 Answer

Brake light on cab works but no rear brake lights at all.Could it be a wiring default or a fuse default?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,338 Answers

Check fuse in fuse box first,at the brake pedal,there's a brake light switch,could just need adjusting,with hand,push pedal in and release to see if switch is going in and out,if working good,then remove,take to Autozone and match up and install and see if it works,if not Autozone will take back.

Posted on Dec 02, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

GM Elec
  • 1000 Answers

SOURCE: 2003 silverado 1500 v-6 brake lights dont work

ljones, Did you check the "VEH stop" fuse in the left side instrument panel fuse box. There are 3 stop light fuses, 1 for all the stop lights located in the under hood fuse box. 2 in the left side IP fuse box. 1 for the upper stop light and 1 for the lower stop lights. The fuse box in the IP is where the upper and lower stop lights split. Let me know.

Posted on Feb 27, 2009

emissionwiz
  • 75822 Answers

SOURCE: Brake lights do not work

This is a well documented problem, replace the turn signal/multifunction switch to correct this issue, this very problem happened on my GMC, it is a 99 as well, replaced the switch as instructed by a chevy forum member and it fixed the problem

Posted on Nov 07, 2008

  • 255 Answers

SOURCE: No rear brake lights on 2006 silverado

brakelight switch above brake pedal. sounds like the prob.at this point.

shack

Posted on Apr 18, 2009

SOURCE: Need to find fuse box inside cab to replace brake light fuse. Brakes don't light up when depressed.

Most fuse boxes are on or near the kick panel (left side of vehicle) under the steering wheel. Some (additional) fuse boxes are under the hood,

Posted on Apr 29, 2009

  • 150 Answers

SOURCE: 2005 Toyota Sienna rear brake light problem.

have you checked the earthing continuity-if it's this other bulbs may also partly light when brakes used
otherwise-
Check continuity of live from center to lh & rh lights and/or is there a live at those lights

Posted on May 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do i find the lamp outage module in a 2000 grand cherokee


did you scan the PCM first.
rear lights dead, not dead dash brake warning light.

check all fuses first?
the fuse is in the cab or under hood
so lets find out where, i open FSM book, and look at schematic
brake lamps
the fuse is in JB box. cab fuse box.
its marked clearly as. Fuse F23 Brakes.
the brake switch is on the brake pedal.
if the fuse is good, 12vdc on both sides.at all times.
then the brake switch is open
if its output is 0v brakes pressed.
if the output is 12v then the switch is good, and the wire
are bad, to the rear.
or both lamps burned out or both sockets bad or wires cut
from trailer hitch hacks,.

Feb 23, 2015 | 2000 Jeep Grand Cherokee

1 Answer

Im looking for color of a brake wire


Hello heinz2127: My name is Roger and i will help you. The rear brake wires are green and yellow. They also are the turn signal wires. The brake lights work through the turn signal switch.The turn signal switch has logistics for determining which side is blinking so as to make the opposite side to show park brake light.Check the fuse box for a blown fuse. Look at the fuse box under the hood. Also try this. Turn on the four way flashers. Step on the brake pedal . The lights should stop flashing If not I would replace the turn signal switch.

May 31, 2010 | 1997 Ford F150 Regular Cab

2 Answers

2002 dodge dakota all lights work and no brake light put new bulb in still no brake lights


check the fuse, it is usually located under the dashboard or between the door and the dashboard.

Oct 14, 2009 | 2002 Dodge Dakota Club Cab

3 Answers

1994 chevrolet pickup - brake light problems


There will be an electronic flasher module located under your dash near the steering column (don't know it's exactly location as it varies). It sounds like this unit may be faulty.

Aug 21, 2009 | 1994 Chevrolet K1500

1 Answer

Rear brake lights don't work


you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

May 23, 2009 | 2005 Chevrolet Silverado 2500HD 2WD

1 Answer

No rear break lights


have you checked all of your fuses often these are ran on seperate fuses also check the wiring for the trailer lights

Apr 03, 2009 | 1995 Chevrolet C2500

1 Answer

NO BRAKE LIGHTS-BOTH REAR AND CAB TOP-NOT WORKING.


check the wiring. could have broken. my problem turned out to be the ground wire on the left light that was not a part of the harness.

Sep 04, 2008 | 2000 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...