Question about Subaru Outback
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I've had the same problem all year. I've had four different mechanics look at this car - 97 legacy with 2.5. I've had the coolant seals replaced, the radiator cap, the thermostat, the water pump - all to no avail. I've realized now that it only overheats shortly after running sustained high rpm's. Recently the last mechanic mentioned the bleeder valve (I didn't know it had one and think maybe he didn't know either - not a subaru mechanic). Recently it overheated again (again sustained high rpm's - apparently more prone to produce air in the system), I sat the vehicle on an incline (raising the bleeder valve to be the highest point) and let the car warm up and run for half an hour. Now 300 miles and no overheat. I went through alot with this car to get to this point. Unbelievable.
Posted on Dec 26, 2008
SOURCE: fuse box location on 2002 Subaru
my books say there are two. one inside vehicle on drivers side below dash to the left of the steering wheel. the other is in the engine compartment on the drivers side by fender
Posted on Jan 09, 2009
there is nothing the shop did the that caused this they do that because of the heat inside the car sitting out in the sun
Posted on Sep 26, 2009
two screws on each headlight control the direction the headlights are aimed. One screw, usually at the top but sometimes below the headlight, adjusts the headlight up and down. The other screw, located to one side, controls the headlight from right to left. Turning the appropriate screw one direction or the other will change the direction the headlight points.
In order to aim your headlights you need to have a flat vertical surface you can aim your headlights at in front of a level surface on which to park the car. If your driveway is level your garage door is the perfect place to aim your headlights.
The tools you will need for this job are simple. Masking tape is used to mark where the headlights are to be aimed and a screwdriver is needed to adjust the headlights. A tape measure will be necessary to measure the distance of the vehicle to the surface you're using to check the aim and to measure the up and down distances from your marks
Posted on Nov 11, 2009
Tips for a great answer:
Jun 17, 2015 | 2002 Subaru Outback H6-3.0 L.L. Bean...
Feb 17, 2013 | 2002 Subaru Outback
Feb 02, 2010 | 2002 Subaru Outback
Jan 29, 2010 | 2002 Subaru Outback
Sep 26, 2009 | 2002 Subaru Outback
May 23, 2009 | 2002 Subaru Outback
Oct 09, 2008 | 2002 Subaru Outback
144 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: