Question about 1997 Mercury Villager

1 Answer

Warer pump how to change it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 14,333 Answers

Click here to see how to replace water pump.

Posted on Dec 02, 2012

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a light in the dash its a watter drop with aexclamation mark


There is a water tank under the Hood take the cap off and fill it with warer

Mar 01, 2015 | Cars & Trucks

1 Answer

What can be the problem on a 1996 Opel Astra 1.4 when the needle on the heat gauge fluctuate a lot. The heat increase when I'm driving faster, and come down when I reduce speed.


Might be fins on the warer pump broke off and not circulating the coolant while driving fast and it doesnt need as much circulation when driving slow

Nov 06, 2014 | Cars & Trucks

1 Answer

Do i need to remove p-stering pump and mount to get the head off on a 200 cavalier,2.2l, or a head diagram wounld be great


Get a Hanes manual from PepBoys for your vehicle.THAT will show you the procedure for everything about the vehicle.

Apr 30, 2014 | 2000 Chevrolet Cavalier

1 Answer

Is the crank pulley pressed on crank for a 93 ford festiva


remove the large bolt at the center of the crank pully and the bolts on the smaller pully and the warer pump pully put jack under oil pan, remove front upper engine mount and lower the jack this will allow you to remove the timing belt cover and then pry off the pully with a large screw driver

Apr 25, 2011 | 1993 Ford Festiva

1 Answer

I have a 1996 chevrolet tahoe. It is leaking raidiator fluid bad but only when running,i tried stopleak and only worked for 2 days.How do i find the leak and how do i fix it?


To find the leak, fill the rad and start the engine. Start by looking for at your rad hoses and radiator for leaks or spray. Don,t forget the heater hoses. Look at the front of the engine behind the fan and see if there is warer running down the front of your engine. That is where the water pump leaks. I suspect that is the source of your leaking problem. The only way to fix your leaks is to replace the leaking part.
If you can,t see any leaks, put a clean dry piece of cardboard under the engine while it is running and use the wet spots to source out the origin of your problem. Hope this helps.

Sep 26, 2009 | 1996 Chevrolet Tahoe

1 Answer

The warer the engine cets the louder the top end


Hi I had the same problem when I purchased GTO, garage replaced engine however a few days later same noise returned, turns out garage had serviced car and used inferior oil, changed to Mobil 1 and have not had any noise since, had car 4 years now! Expensive mistake by dealer !!

Aug 27, 2009 | 1991 Mitsubishi 3000GT

2 Answers

Leaking hose in front of engine


This means you have a leak on your cooling system.Be very careful with that as if you are not careful it will end up blowing the head gasket which will be costly to fix.My suggestion is to find the leak, drain the cooling system and fix the leak which will be less costly and easier than having a replacement head gasket.

Jun 25, 2009 | 1996 Chevrolet Cavalier

2 Answers

MY 1999 PLYMOUTH BREEZE KEEPS OVERHEATING!!!


sounds like head gasket needs replaced it is getting air in the system and back flowing to the easiest spot to get out

May 16, 2009 | 1999 Plymouth Breeze

Not finding what you are looking for?
1997 Mercury Villager Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...