Question about 2001 Mercury Grand Marquis

1 Answer

Driver's side door panel

Hi, I need to remove the inside door panel of my 2001 Mecury Grand Marquis and I cannot seem to find how to remove it. I can remove the panel that holds all the buttons for windows and doors but I cannot find all the screws to remove the panel.

Can you help?

Marvin

Posted by on

  • 1 more comment 
  • bmk296h Jan 15, 2009

    To whom it may concern;



    Sorry I did not respond sooner but I have not had the opportunity to try again to fix my problem. As soon as I do I will contact you.



    Thanks for responding so quickly



    bmk296h

  • bmk296h Jan 18, 2009

    Thanks for trying, but your suggestions do not work. I finaly did remove the panel. This is how it is done. 1st there are 5 screws that hold the panel to the door, there are no clips. 2nd The section where the buttons to open and close the window are must be pried up, it is the only thing that is held by 2 clips. 3rd after lifting the panel that has the buttons you will find a screw that must be removed. 4th the door handle that you grab to close the door has2 screws that must be removed, they are hidden behind to removable plastic plugs. 5th There are 2 more screws to removed. One is near the left side past the armrest, the other is at the bottom of the padded part of the door to the left of the door pocket. 6th after all the screws are out grab the door panel at both sides and lift up. There are about six wide plastic hooks that drop into holes. That is what keeps the door panel on. Again, thanks for trying but I had to figure it out myself.



    bmk296h

  • Anonymous Mar 16, 2009

    I was replacing the mirror on the driver side of 2000 Merc Grand Marquis - your tips helped me - got everything off. Still painting new mirror housing so wish me luck putting it back together!!

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

They have clips that you can pull them in and out, so try to pull the door panal out slowly and see what happen then ok, get back to me ok.

Posted on Jan 11, 2009

  • 1 more comment 
  • Ramon Velasquez
    Ramon Velasquez Jan 16, 2009

    It has no screws, It has clips. just pull it out slowly, It might has two screws in the two bottom ends.

  • Ramon Velasquez
    Ramon Velasquez Jan 17, 2009

    try pulling it out.

  • Ramon Velasquez
    Ramon Velasquez Jan 18, 2009

    good. good job

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How To Install Replace Rear Inside Door Handle Mercury Grand Marquis 98-02...


How To Install Replace Rear Inside Door Handle Mercury Grand Marquis 98-02 1AAuto.com

on May 22, 2012 | 2001 Mercury Grand Marquis

1 Answer

Power Windows on a 2001 Grand Marquis LS


all of it is run through the drivers switch so I would say drivers switch is bad .

Jul 02, 2012 | 2001 Mercury Grand Marquis

1 Answer

2004 mecury grand marquis heater or ac will not blow out air thru the vents, it will defrost but little air comes out


check the doors in the heater ductin and make sure all the door motors r workin properly

Dec 21, 2009 | 2004 Mercury Grand Marquis

1 Answer

How to replace passenger side outside mirror on a 1997 Mercury Grand Marquis?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. You can then remove the bolts securing the mirror onto the door

Sep 18, 2009 | 1997 Mercury Grand Marquis

1 Answer

Location of starter on 1995 mecury grand marquis


on the 4.6 motor the starter is on the pass.side....3#--- 10mm head bolt retain the starter to the bell hse. top inner is tuff to get to... disconnect battery prior to removal....hope this helped...GL

Jul 06, 2009 | 1995 Mercury Grand Marquis

1 Answer

Temperature sensor 2000 Mecury Grand Marquis


Make sure that is the sensor. That should be your oil pressure sensor. Follow the top radiator hose to the thermostat look closest to that for the wire going to the sensor. This should be the temp sensor. Good luck

Mar 20, 2009 | 2000 Mercury Grand Marquis

1 Answer

Mercury Grand Marquis '93 problem


It would be easier just to disconnect the components in the door and pull harness out of door.The harness is inside the black accordion rubber tube between door and body,just unsnap it at door then pull harness thru.

Feb 16, 2009 | 1993 Mercury Grand Marquis

1 Answer

How do I remove the inside door panel of a 2001 Mercury Marquis


Pop out the window buttons part of the armrest and disconnect the wires. Do the same with the trunk and fuel door buttons. Pop out the two little plastic/rubber whatever they are pieces out of the door pull strap and remove those screws. There's another screw on the bottom edge of the door and the outer edge by the reflector. Pop the bezel out from around the door handle and there's another screw. Pull out and up on the door panel. If you don't know your door code now would be a good time to write down that 5-digit number on the lock control box. You might not have to pop out the button panel or trunk/fuel buttons if you can get your hands behind the panel and take the harnesses apart but you a bad dude if u can.

Jan 11, 2009 | 2001 Mercury Grand Marquis

1 Answer

How do I remove the inside door panel on drivers side


you need to take out the door panal and work from the inside of the panal. Open it from there.

Jan 11, 2009 | 2001 Mercury Grand Marquis

Not finding what you are looking for?
2001 Mercury Grand Marquis Logo

331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...