Question about 2002 Cadillac Escalade

Open Question

2002 escalade wheel wobbles

Tires look ok , no top and bottom play in hubs with tire raised but there is play when pulling front and back of wheel with tire raised ( either side)

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: front wheel bearing replacement

Remove the lugs than disassemble the brake calipers remove the disc take a 3lb sledge hammer and swing it and hit the back side of where the lug studs are sticking out

Posted on Dec 06, 2008

cadman000
  • 607 Answers

SOURCE: 2002 cadillac escalade driver side back window stuck.

If you cannot operate the window from either switch, I'd first test switch continuity and operation, both front and rear. If they both pass muster , I'd have to say the fault lies behind the door trim, probably the motor, which also be tested once reaching that point..

Posted on Mar 28, 2009

rteemon
  • 578 Answers

SOURCE: 1997 Cadillac Deville vibration

suspension problem my friend have it check

Posted on Jul 01, 2009

  • 167 Answers

SOURCE: I have a 05 Cadillac Escalade and the sterring

Have them check the universal joints, front and rear, as well as the two on the front shaft if it is a four wheel drive model, the CV joints on the front axle if 4WD, the drive shaft(s) for straightness, mud in wheel recesses, and the rear end and front differential "chunks."

Posted on Feb 26, 2010

  • 6982 Answers

SOURCE: I have abnormal wear on

Tire wear as you outlined is caused either by incorrect toe in or camber setting. Both are components of wheel alignment. Regardless of what you were told, there is no other way that happens.
As to who gets to pay for it depends on your agreement.

Posted on Mar 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes the car to wobble side to side at the get go


your suspension, or a bent rim,or a bubble, where your tire is separating. jack your car up, put a jack stand under it, spin your tire, watch for wobble(this will tell you,if its your wheel, or tire. while in the air grab the front and rear of tire pull, and push oppisites, then do the same with the top and bottom, there should be no play. if there is, its your suspension.

Oct 07, 2012 | 2001 Honda Civic

1 Answer

1993pontiac grand am front wheels wobble while driving


Jack up the front wheels and rotate them by hand. Look for any runout that may be cause by a bent wheel. Also feel the tread as you rotate the tire. It should be smooth and concentric. If there are any bulges in the tread the tire is seperated. Grab the wheel at the top and bottom and push/pull. You should feel no play. If you do you woman have a bad wheel bearing. In order to check ball joints and tie rods you will need to have the tire off the ground and the jack under the subframe or pinch weld. This will not work if the jack is under the control arm. Grab the tire at the 9 and 3 o'clock positions and push pull. If you feel any play you either hav E worn ball joints or worn tie rod ends. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 08, 2012 | 1993 Pontiac Grand Am

1 Answer

When im driving the car moans and moans even louder when i turn the wheel, the faster i drive the louder the sound gets


You should check the power steering fluid level first. However, you said the noise gets louder if you turn the wheel. That sounds like a front hub bearing. To check the front and rear hubs, raise the tires off the ground one at a time. Try to move the tire in & out at the top, sides and bottom. spin the tire if you can. Only a tiny amount of play, if any, is acceptable. If you hear or feel rumbling or roughness when turning the tire, the hub is bad and must be replaced

Aug 03, 2011 | 2004 Chevrolet Cavalier

2 Answers

When you drive down the road,and you get over 25 mph theres a wired noise sounds like grouwling


This is one or both of your front wheel bearings, jack the front of the truck up and spin the wheels by hand feel or listen for any noise or roughness, also grab two side of the tire tip and bottom and pull in out, if there is play then your bearing is bad, another possibility is a bad tire but wheel bearings are all to common on these trucks please rate

Jul 31, 2011 | 2002 Chevrolet Blazer

1 Answer

We checked the brakes and they were fine but when she goes to stop we hear agrinding noise and when we drive and hit a bump you can hear the a noise like we are riding with 24 inch tires but it is all...


You are correct in suspecting the front hub bearings, do the following to confirm first, and if needed I can walk you through replacement if you think you are capable of performing the repair yourself.
-Raise the front of the vehicle on a suitable jack so that one of your front tires is completely off the ground.
-Grasp the top and the bottom of the tire and try to wobble the tire and wheel assembly top to bottom, (on a vertical axis). If there is any play whatsoever, replace the bearing. Do the same for the other side.
-If no play was detected, do the following. Take the vehicle for a test drive, while driving approx 45mph, substantially sway the side to side. Does the tone or pitch of the noise change with the direction of the sway? If so, again, the bearings are bad. Write me back with the results of these tests and I will tell you which one to replace. Thanks...

Mar 12, 2011 | 2002 Mazda Tribute

3 Answers

My left front tire is wobbling and I don't know why. I have attempted to take the tire off and put it on again. What could be wrong?


WOBBLING TIRE IS A BAD WHEEL HUB BEARING.REMOVE WHEEL CHECK HUB BEARING WHERE FRONT AXLE MESH INSIDE HUB.SHAKE HUB BEARING SEE IF IT REAL LOOSE AND WOBBLY. IF YES HUB BEARING BAD.

Dec 04, 2010 | 1996 Saturn SL

1 Answer

My 2004 f-250 front end wobbles side to side @ about 45 mph and lopes when U turn sharp and back up. Has new tie rods. What might cause this? S.M.


Sounds like a belt shift in a front tire. Raise the vehicle and spin each front wheel while looking at the bottom surface from the front. Look for "runout" or a wobble in the bottom surface of the tire. You can also rotate the tires and see if the symptom moves to the rear

Nov 14, 2009 | 2004 Ford F250

2 Answers

Side to side wheel play


It could be an indication of a bad wheel bearing assembly. Did you check the lug nuts to be sure they are tight? It could also be the tie rod assembly. I would take off the wheel and try to move the just the hub assembly. Do you hear any screeching/squealing noises? Any popping while you are driving? Are your tires wearing? All these are classic signs of a bad wheel bearing. Any decent tire/auto shop can put your car on a lift and check the wheel bearings.

Jul 24, 2009 | 2001 Dodge Stratus

1 Answer

I have a toyota corolla 91. I can wobble the front tires by hand back and forth about 1 to 2 inches. When driving, the front tires wobble. Is this the front or back tie rods?, Do you need tools you...


Possible wheel bearing failure, ball joint failure or tie rod end failure. Does the wobble seem to be when tire is moved toward center of vehicle on top and bottom or front and back??

Mar 29, 2009 | 2002 Ford Taurus

2 Answers

1997 jeep cherokee sport 4x4 straight 6 4.0 with grinding,slash wheel wobbling sound only out of driver front, i have changed brake pads, caliper, rooter, and replaced the rubber grommit on the tie rod...


Jack up the jeep and spin the wheel by hand, does it rotate smoothly? Grab the tire at top and bottom (while off the ground) and try to pull the top of the tire out while you push the bottom of the tire in. Have someone watch to see if the the tire is moving in and out, it shouldn't. Also grab front of tire at middle, and back of tire at middle and try to move in and out. You should not see any movement. If you do, your wheel bearings may be shot, also check your axle U-joint to see if it's shot. Good Luck! Countrycurt0

Aug 02, 2008 | 1988 Jeep Cherokee

Not finding what you are looking for?
2002 Cadillac Escalade Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...