Question about Toyota Cars & Trucks

Open Question

Were is heater controll valve located on my 1997 camry

Locate heater controll valve on 97 camry

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: location of the heater control valve

There are 2 hoses going through the firewall from the engine, these are the coolant hoses to the heater core, one is 3/4" and one 5/8", the control valve should be in the larger line (3/4") which is the inlet, make sure that the valve has vacuum (heater on low), also check and see if both hoses get hot with the heater blower on low, if they do get hot your problem is not the heater control valve but the air temp control blend door actuator.

Posted on Dec 28, 2008

  • 83 Answers

SOURCE: location of heater control valve 2005 grand prix

i don`t think there is a heater control valve.you may have an air pocket in system.

Posted on Jan 06, 2009

  • 396 Answers

SOURCE: where is the heater control valve locatedon a 2002 mitsubishi

Most heater control valves are on or near the firewall behind the engine. Look for coolant hoses attached to a small metal piece. It also will have an arm that has a cable from inside the vehicle attached to it.

Posted on Oct 19, 2009

  • 87 Answers

SOURCE: 2002 camry 2.4. Where is the idle air control

it is on the throttle body i would try to clean the throttle body first before replacing it

Posted on Mar 03, 2010

  • 14036 Answers

SOURCE: where is the location of

YOU GETTING INTO LOT OF DISASSEMBLY TROUBLE YOU HAVE REMOVE WHOLE DASH AND TO GET HEATER CORE YOU HAVE TO REMOVE WINDSHIELD WIPER MOUNTING ARM AND THE PIVOT.SHAFT.YOU HAVE REMOVE ELECTRICAL CONNECTOR.YOU HAVE TO REMOVE UPPER COWL EXTENSION SCREW AND THE EXTENSION.REMOVE VACUUM HOSES AND THE WIRE HARNESS CONNECTOR FROM THE EVAPORATIVE EMISSIONS CANISTER PURGE VALVE NUTS AND THE VALVE.REMOVE COWL SIDE NUT.YOU HAVE TO REMOVE RIGHT SIDE REAR FENDER APRON SCREWS AND REPOSITION THE APRON.REMOVE EVAPORATOR HOUSING NUT AND SCREW.YOUR HEATER CORE INSIDE EVAPORATOR HOUSING YOU HAVE TO REMOVE HEATER CORE FROM THE RIGHT REAR OF FENDER FROM EVAPORATOR HOUSING.YOU HAVE TO REMOVE DASH TO DISCONNECT HEATER HOSES, REAR AIR DUCTS,REMOVE EATC CONTROLLER AND DISCONNECT OTHER ELECTRICAL HARNESSES YOU HAVE A BIG JOB.GOOD LUCK.YOU WILL NEED A REPAIR MANUAL TO SEE INSTRUCTIONS.

Posted on Nov 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stop my car remove key idle control valve start stop 15 second start again do that until battery drain.Clean valve put it back same problem


Camry Idle Air Control Valve Cleaning - YouTube

? 3:50
https://www.youtube.com/watch?v=i82s4ZfR2js
Aug 23, 2009 - Uploaded by yuandrew
This is my Father's 1999 Toyota Camry with the 3.0 liter V6 (1MZ-FE) ... About every three years, the Idle Air ...

How To Clean Idle Air Control Valve And Throttle Body On ...

? 6:33
https://www.youtube.com/watch?v=aHHhRDTVWbo
Nov 10, 2013 - Uploaded by hondapartshero
How to clean 94-97 Honda Accord F22B idle air control valve. ... You don't show how to remove the two 12mm ...

Jan 10, 2016 | Cars & Trucks

1 Answer

Where. Orfice located in air conditioner system on 2002 camry


This vehicle uses an expansion valve and will not have an orifice tube I believe. The heater box assembly has to be removed for access of this valve

Jul 20, 2015 | 2002 Toyota Camry

1 Answer

Heat dont work


no heat is cause by many things (coolant not at 180F and holding?)
no blower?
damper closed.
as you said the water valve.
location:
see heater, see the core, see the 2 brass tubes passing thru the fire wall. ? they go to hoses. and if car has a valve its there.
some cars dont use a valve at all.
ill look yours up. USA spec car. bingo on valve.
so here is 91, camry. im looking now, its just like i said above
at the fire wall hose; to heater core.
what i do is here.
1: engine hot?
2: are both above hoses hot, (no fail, yes, good.)
here is a list of every heater failure possible.

http://www.fixkick.com/AirCond/heater.html


it's only 2 rules.
air must flow
the hot water must flow.
or it fails.


you can look at any time at alldata.com
or buy the FSM. for best play, (i promise)



Dec 24, 2013 | 1991 Toyota Camry

2 Answers

Heater control valve 97 GMC Sierra


Temperature is controlled by an air mix door inside the HVAC compartment. This door is either electrically actuated if you have an electronic climate control system, or a cable for manual control. Most probable cause is a failed electric actuator (air mix door control module).

Apr 17, 2017 | 1997 GMC Sierra

1 Answer

I have a 97 nissan terrano and the heater blows basiclly no heat, fan works fine, where is the problem? have been told pollen filter,flush radiator and possible heater coil?


Nissian has what is called a heater control valve . It is located under the hood in the heater hose going to the Heater core ( not coil ) this vavle controls the flow of coolant going into car it can be plugged or dissconnected . Start by having this checked before any thing else .

Aug 05, 2012 | 1997 Nissan Pathfinder

1 Answer

Where is the heater control valve located on a 97 ford taurus


The Taurus does not have a heater control valve. Coolant flows through the core at all times.

Jan 13, 2011 | 1997 Ford Taurus

1 Answer

1990 Firebird no water in the heater


You have a froze heater control valve or broken control valve linkage cable!

Jan 19, 2010 | 1994 Toyota Camry

1 Answer

Camry dies out when coming to stop


IAC idle air control motor, or, it could be the torque converter not unlocking properly.

Aug 18, 2009 | 1997 Toyota Camry

1 Answer

Heater


check the heater control valve. its a plastic valve in the engine compartment, ensure the cable is attached and also ensure that the valve moves when heat is selected. also it is possible that someone has bypassed the heater core due to a leak. check to make sure both hoses are still connected.

Oct 28, 2008 | 1992 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...