Question about 2002 Buick Rendezvous

Open Question

How do you remove boot off steering column off 2002 buick rendezvous

Changing engine... can't get boot off of steering column shaft...won't move up or down

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

SOURCE: 1993 buick regal steering column repairs

http://www.alldatadiy.com/

Posted on Aug 31, 2008

Ad
  • 54 Answers

SOURCE: O2 sensors on 2002 buick rendezvous

hi im wes the o2 sensor is always in the exaust newer buicks have one before the converter (sometimes in the exaust manifold) one after the converter if it has duall exaust it could have four
left bank sensor one is before the converter on drivers side bank two sensor 2 would be passanger side after the converter does this help?

Posted on Mar 12, 2009

  • 201 Answers

SOURCE: Steering wheel removal buick century 2002

look on back side of center cushion arms,there are fastners there that hold this peice on then rest is easy..

Posted on May 09, 2009

  • 2 Answers

SOURCE: 2002 Buick Rendezvous alternator removal

To get the alternator out, I had to move that large electical fuse / relay box out of the way,and remove washer bottle and battery. then use a 3/8" drive ratchet to move the tensioner forward to get the belt off. I used a small mirrow to get a view of the back bolts on the alternator and removed them.[ I used meteric # 15 open end & closed end combo wench. Keep turning the back bolts until the alternator become loose.]

Posted on Jul 04, 2009

  • 436 Answers

SOURCE: Buick Rendezvous 2002 need codes?

the BCM needs to be programmed to operate the computer. a GM techII is now required to calibrate BCM to airbag, stereo, keyless entry, and control pcm data. This is required to make it all work. a gm service should have it done within an hour or less just call and ask them how much it would be to program new BCM. it might cost @$75 to $125 but it is needed, to allow the BCM to work properly.

Posted on Sep 11, 2009

Testimonial: "ok...i bought the bcm on line (used)...but the gays in the dealer says i have to buy a new one..because the used cannot be to reflashed...or recoded."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove steering column on a 2005 Buick LeSabre


Steering Column Replacement Hope this helps?

Tools Required

• J 42640 Steering Column Lock Pin
• J 41352 Modular Column Holding Fixture

Removal Procedure

    Warning! Refer to SIR Caution in Cautions and Notices.
    Caution! The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the coil assembly.
    Caution! Once the steering column is removed from the car, the column is extremely susceptible to damage. Dropping the column on its end could collapse the steering shaft or loosen the plastic injections which maintain column rigidity. Leaning on the column could cause the jacket to bend or deform. Any of the above damage could impair the column's collapsible design. If it is necessary to remove the steering wheel, use only the specified steering wheel puller. Under no conditions should the end of the shaft be hammered upon as hammering could loosen plastic injections which maintain column rigidity.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.



  2. Insert J 42640 into the steering column access hole in order to lock the steering column. This will maintain the correct orientation.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.



  4. Remove the intermediate shaft lower pinch bolt.
  5. Remove the intermediate shaft from the steering gear.
  6. Lower the vehicle.



  7. Remove the knee bolster. Refer to Bracket Replacement - Knee Bolster in Instrument Panel, Gages and Console.
  8. Disconnect the steering column wiring harness connector from the main body wiring harness.
  9. Disconnect the shift lever cable from the linear shift assembly.



  10. Remove the shift cable retaining clip.



  11. Press the shift cable tabs (1) together and remove the shift cable (2) from the steering column.



  12. Caution! The steering column should never be supported only by the lower support bracket. Damage to the lower support could result.
    Important Stabilize the studs in order to remove the nuts securing the steering column to the instrument panel.
  13. Support the column.



  14. Remove the lower steering column retaining nuts.
  15. Remove the upper steering column retaining nuts.
  16. Important Discard the clips at the upper steering column support, if equipped. These clips are for assembly plant usage only.
  17. Remove the steering column from the vehicle.
  18. Install the steering column into J 41352 .

Jan 06, 2018 | Buick LeSabre Cars & Trucks

1 Answer

Rack and pinion removal


remove the left and right tie rod ends from the from the pivot arms , remove power steering oil lines, remove steering wheel shaft to rack pinion clamp, with wheels in straight ahead position remove rack hold down fittings, slide pinion off steering shaft and remove rack.

Jul 10, 2015 | 2002 Buick Rendezvous

2 Answers

How to remove a steering column on a 95 Buick Lesabre and remove the steering column on a 92 Pontiac Bonneville to replace it with the on from the Lesabre


First remove bolt that attaches to the steering box it may have a rubber boot over it then undo shift linkage under the dash I can remember if there's 2 or four bolts take them off column drops down unhook electrical and pull out hope this helps

Jan 03, 2015 | Pontiac Cars & Trucks

1 Answer

What power steering fluid is for buick rendezvous 2002?


if you can't get regular power steering fluid you can use Dexron 3 transmission fluid for power steering.

Oct 14, 2014 | 2002 Buick Rendezvous

1 Answer

Location of computer diagnostic port on a 2002 rendezvous


Data Link Connector(DLC) is Below Steering Column.

Jun 04, 2014 | 2002 Buick Rendezvous

1 Answer

Where is the water pump on 2003 buick rendezvous


It's on the passenger side of the engine. If our standing in front of the car it is just in front of the power steering pump and right above the a/c compressure. It hhas a smooth pulley.

Aug 23, 2012 | 2002 Buick Rendezvous

2 Answers

Reset theft system in 02 Buick Rendezvous


Just turn the key on, if that doesn't reset it you have a failed part and will need the help of the dealer

Jun 16, 2012 | 2002 Buick Rendezvous

2 Answers

I`ve replaced my steering column and my car won`t start? Do I have to reprogram my computer or something?


Double check the wiring to the ignition unit and make sure everything is still lined up correctly.

Oct 28, 2010 | 1995 Buick Riviera

1 Answer

How do you remove the rack and pinion from a 2002 cadillac deville. there is a rubber boot connected to the steering gear and the steering column, how do you remove this boot?


set steering whell straight. push rubber boot up there is a 12mm/7-16 bolt that connects the steering shaft to the rack and pinion removeboth fron tires remove p/s lines and all other fastners for the rack and pinion

Aug 13, 2010 | 2002 Cadillac Deville

Not finding what you are looking for?
2002 Buick Rendezvous Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...