Question about Mitsubishi Mirage

Open Question

Is there a fuse for fuel gauge 2000 mitsubishi mirage

Gas gauge does not register, is there a fuse for gas gauge

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: How to replace a fuel filter for a Mitsubishi Mirage 2000

There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!

Posted on Mar 15, 2009

Ad
bad_dog1
  • 104 Answers

SOURCE: Toyota Avalon XLS 2000 Fuel Gauge and Compass

the other areas the fault could be located are in your meter circuit plate (which is part of your combination meter), it could be in the wiring, or possibly your multi display (also part of your combination meter)

Posted on Mar 15, 2009

emissionwiz
  • 76691 Answers

SOURCE: gas gauge not working right for 2000 silverado

the only thing that will cause this symptom is the fuel tank sending unit.

Posted on Jun 03, 2009

  • 88 Answers

SOURCE: fuel pump relay for 2000 mitsubishi mirage

most newer veichles your feul pumps in your gas tank

Posted on Aug 22, 2009

sk8rdude_88
  • 27 Answers

SOURCE: 1995 Mitsubishi mirage. no gas to fuel injector

i would replace the fuel pump. and the reason your gas gage is not reading what it is supposed to be is because the sending unit is prob bad. both of which are in the gas tank. im not sure on that year but i think you can remove the back seat or a piece of the trunk to get to both of them. if not the gas tank will need to be dropped to get them out

Posted on Nov 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Mitsubishi mirage 1.8 ltr 4g93 ran out of gas now it wont start. How do i get it started again.


Spray starting fluid into the air intake of the engine, it will start, if it dies out then you have burned out the electric fuel pump located inside the fuel tank, the reason is that when you run out of fuel the pump overheats and the shaft seizes up. You should never let the fuel level go below 1/8 tank on the gauge, the pump is cooled and lubricated by the gasoline it sits in, no fuel no cooling or lubrication.

May 06, 2016 | Mitsubishi Cars & Trucks

1 Answer

The gas gauge is not working properly. How can it be fixed?


either the gauge is failing or the ground wire to the fuel gauge in the tank is failing or you need the whole thing.

Aug 10, 2010 | 2001 Mitsubishi Mirage

3 Answers

95 mitsubishi mirage has fire wont start


check for fuel pressure should be around 45 to 55 psi there should be a valve on the fuel rail with a black plastic cap kinda looks like a bike tire valve u will need a fuel pressure gauge .

Jan 08, 2010 | 1995 Mitsubishi Mirage

1 Answer

1995 Mitsubishi mirage. no gas to fuel injector and i do not hear the fuel pump when i turn on the ignition switch. also gas tank is full and the fuel gage reads empty on the dash board. can not locate...


i would replace the fuel pump. and the reason your gas gage is not reading what it is supposed to be is because the sending unit is prob bad. both of which are in the gas tank. im not sure on that year but i think you can remove the back seat or a piece of the trunk to get to both of them. if not the gas tank will need to be dropped to get them out

Nov 19, 2009 | 1995 Mitsubishi Mirage

1 Answer

Where do i find fuel pump fuse or relay for 2000 mitsubishi mirage?


under the hood there is a second fuse and relay box on the drive5rs side, under the lid will tell you the location of each fuse and relay

Aug 22, 2009 | 2000 Mitsubishi Mirage

2 Answers

Fuel pump relay for 2000 mitsubishi mirage


most newer veichles your feul pumps in your gas tank

Aug 22, 2009 | 1993 Mitsubishi Mirage

2 Answers

I am looking for the location of the plugs on a 2000 mitsubhi mirage with a 1.8 litre engine


Are you referring to the SPARK plugs? The Mirage's 1.8 engine does not use standard spark plugs, because it is fuel injected. It uses 4 fuel injectors that has gas hookups & electrical hookups. They are located on the head in the back.

Jul 28, 2009 | 2000 Mitsubishi Mirage

3 Answers

How to change out flasher fuse i have the fuse just need to know where it is located at


Here ya go...please don't forget to rate!

1997–00 Mirage engine compartment fuse location chart

f452915.gif
The turn signal and hazard flasher unit is located in the interior fuse panel located under the driver's left side knee protector. They are replaced by simply pulling them straight out. Note that the prongs are arranged in such a way that the flasher must be properly oriented before attempting to install it. Turn the flasher until the orientation of the prongs is correct and simply push it firmly in until the prongs are fully engaged

Jul 13, 2009 | 1995 Mitsubishi Mirage

1 Answer

Mirage Mitsubishi 2000


The fuel filter is located in the engine compartment,mounted to the firewall..Lower right hand side

Mar 06, 2009 | 2000 Mitsubishi Mirage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...