Question about Pontiac Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Yes, You can buy a manual at your lacal parts store.
However, It's not that hard. But , you didn't say if you
need to change the front or rear pads?
I'll assume your refering to the front.
1st You'll need to jack up the car if you only have one
Jack then, pick the side you are too start say left front.
Jack the car up like chainging a tire BUT, Jack the car
up but, leave the tire touching the ground with, some weight
still on the tire with a lug rench turn the lug nuts JUST enought
to loosin the nut DO NOT take the nut off, maybe 1/4 " only.
Do the same on the others. Now, Jack up the car until the tire
is off the ground. NOW, Put a Jack Stand under the car never
NOT use a stand. Remove the nuts and tire.
Turn the wheel to the right it will give you more room to work.
You'll need to remove the caliper that holds the pads on.
There are two screws that hold the caliper on. I believe,
there 13mm remove the screws (Take them all the way OUT)
Remove, The caliper the pads, will stay in the holder.
Remove, the pads you may need a screw driver to get the
pads out.There are two pads that have a scencer on them
one for each side PUT that pad on the inside holder.( sencer down)
NOW rember you need, too make room for te new pads.
You need a c- clamp to push the piston BACK into the
bottom of the caliper. Be sure the piston is at the bottom of the caliper
or the caliper will NOT fit back on. Install the new pads into the holder.
.Then, put the caliper back on to it's mount over the new pads.
Put the two caliper bolts back and, your done.
Reverse, the infromation from the top.
Posted on Jan 02, 2010
Testimonial: "Thank u"
Have you checked the coolant level? If that checks out ok... With the engine fully warmed up touch the heater core hoses where they go into the fire wall (about the center of the firewall). They both should be pretty hot to the touch. You'll likely find one hot and one warm. If this is the case flushing the heater core will likely get your heat blowing out hot again.
Posted on Mar 07, 2010
Pontiac stopped installing the fuel filter on the rail in 2006. The 2004-2005 models had a fuel filter on the driver's side under the rear passenger seat area clipped to the frame. 2006 beyond the fuel filter is part of the fuel pump unit inside the tank.
Posted on Jun 01, 2010
YOU HAVE TO REMOVE CRANKSHAFT HARMONIC BALANCER TO REPLACE CRANKSHAFT SENSOR.ITS LOCATED BEHIND IT.YOU NEED A HARMONIC BALANCER REMOVAL AND INSTALLER TOOLS.
Posted on Sep 13, 2010
Tips for a great answer:
Feb 20, 2013 | 2006 Pontiac Grand Prix
Sep 05, 2012 | 2006 Pontiac Grand Prix
Aug 30, 2012 | 2006 Pontiac Grand Prix
Aug 18, 2010 | 2006 Pontiac Grand Prix
Jun 26, 2009 | 2006 Pontiac Grand Prix
Jun 12, 2009 | 2006 Pontiac Grand Prix
Apr 19, 2009 | 2000 Pontiac Grand Prix
Apr 11, 2009 | 2006 Pontiac Grand Prix
Mar 18, 2009 | 2006 Pontiac Grand Prix
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: