Question about Volkswagen Golf

1 Answer

Vw golf 1.6tdi 2009 fault code 7313 function restriction due to received malfunction value u1113 upper limit exceeded

Posted by Anonymous on

  • Rupinder Sandhu
    Rupinder Sandhu May 29, 2015

    Hi did you to the bottom of the problem - i have same fault on my skoda

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 2,019 Answers

I believe this may mean the MAF is giving an excessive reading. The harness may be loose, there could be oil foam insulating it, or something else worth taking a visual inspection.

Posted on May 30, 2015

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 06 vw sharan 1.9tdi exhaust warning light on

can you tell me the resistances in ohms of the EGR valve

Posted on Feb 01, 2009

  • 491 Answers

SOURCE: vw golf mk 4 electrical problem

CHECK AUXILIARY BELT FOR DAMAGE AND ALTERNATOR BRUSH LENGTH

Posted on Jul 20, 2009

  • 34 Answers

SOURCE: 2002 vw passat....starts fine and drives

It appears that your brake booster system has a major vacuum leak which is causing the engine to go lean and stall. Check the hose between the intake manifold and the brake booster. It may be cracked or loose causing outside air to enter the hose when the brake is applied.

Posted on Jan 15, 2010

alicantecoli
  • 22156 Answers

SOURCE: CAN YOU TELL ME FAULT

P3011 Fuel pump relay - short to positive

Posted on Sep 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vw golf 2.0 codes p0122 p0222 p1296 p0638


Hi, have there been any running issues. I have replaced a few acclerator pedal units due to the codes. p1296 is different and further diagnosis would be rquired as this is a general cooling system fault.

Mar 20, 2014 | 2001 Volkswagen Golf

1 Answer

Vw golf 1998 safe code 1000 how to change it


1 enters the 1st place value, 2 enters the second place value, 3 enters the 3rd place value, 4 enters the 4th place value. press the buttons as required to enter your code. if you enter it wrong and it locks up, you will have to leave the ignition and the radio on for 1 hour.

Jan 18, 2014 | 1998 Volkswagen Golf

2 Answers

Engine malfunction


run fault codes and find which sensor is causing the problem. It is a good idea to heed the engine light immediately as it is there to advise you of something wrong that will cause damage to the engine or transmission

Jan 04, 2014 | Nissan Pulsar Cars & Trucks

1 Answer

Help please, my vw golf 1.6 sr is loosing mad power. it wont accelerate properly and the revs arent going past bout 2000rpm, rev counter sits below 0 when idling?? it takes ages to even get up to 30


IF YOU SEE CHECK ENGINE LIGHT FLASHING LOOK FOR TURBOCHARGER WASTEGATE REGULATOR VALVE FAULT OR MAP SENSOR FAULT.THAT COULD BE YOUR PROBLEM.IF NO CHECK ENGINE LIGHT FLASHING YOU COULD HAVE A RESTRICTED EXHAUST SYSTEM BAD TURBOCHARGER, RESTRICTED FUEL FILTER.ALL THOSE THINGS WILL CAUSE POWER LOST.

Aug 04, 2011 | 1999 Volkswagen Golf

1 Answer

Ihave a 2001 vw golf 2.0l, the EPC light has come on. I,ve connected a fault code reader and it,s come up with code 16955 does anyone know the problem please.


Code points to "Cruise/Brake Switch (A) Circ Malfunction" which means the switch or connections might be bad. Most VW's of this era had a recall on brake switch, check with dealer to see if your car had it replaced. Stop lights might be out, cruise not working. Replace switch if any of these conditions present.

Feb 18, 2011 | 2004 Volkswagen Golf

1 Answer

Hi i hit my mark 3 vw golf into a ditch and now the left hand side wheel is bent and possibly the ball joint or drive shaft. Will i be able to use parts from a vw polo of similar age. Will the vw polo...


Simple answer: No. Polos and Golfs use different mechanical components.

More complicated answer: If there is that much damage then the bodyshell mountings are also quite likely to be distorted which will make any repair attempt futile. Ideally you must get the damaged parts stripped off and then get the mounting points accurately measured. This can only be done using specialised measuring equipment. The alternative is to invest in the parts needed for your repair and to fit them with an immediate alignment check at the nearest suitably equipped garage. If the alignment of the body is off then the car is effectively a write off as repairs will exceed the car value.

Oct 06, 2010 | 1997 Volkswagen Golf

3 Answers

A p0301 p1142 p1545


CODE PO301 - CYLINDER NUMBER 1 MISFIRE DETECTED. POSSIBLE CAUSE- BAD COIL - SPARK PLUG - INTAKE MANIFOLD VACUUM LEAK - DIRTY OR FAULTY FUEL INJECTOR. CODE P1142 - DID NOT SEE. CODE P1545 - THROTTLE VALVE ACTUATOR MALFUNCTION.POSSIBLE CAUSE THROTTLE VALVE CONTROL MODULE FAULTY - THROTTLE VALVE IS DAMAGE OR DIRTY - THROTTLE VALVE MUST BE IN THE CLOSE POSITION - ACCELERATOR PEDAL OUT OF ADJUSTMENT. THROTTLE POSITION ACTUATOR IS SHORTING TO GROUND OR POWER.

May 09, 2010 | 2000 Volkswagen Jetta TDI

1 Answer

Epc light on 2001 golf mark 4 car running ok, what


EPC: Electronic Power Control

The ME7 engine management system uses electronic controls to operate the throttle valve rather than the usual braided cable. Pedal resistance and operation matches cable designs so that the operator is unlikely to differentiate. In an event of a failure with either one of the accelerator pedal position sensor (G79 or G185), the other sensor signal would be used in a limited capacity with functions such as cruise control deactivated. If both sensors malfunction, the ECM will limit engine speed to proximately 1200 rpm.

Now as to your question regarding error codes (DTC, SAE/VAG fault codes), as VW scan tool or similar needs to be hooked up to your vehicle in order to read which ones are stored in the ECU. This codes will tell you which area of the system came from and what problem they are related to. Only with a scanner makes all this possible, without it, it would be an expensive guessing game besides being very unreliable.

Apr 07, 2010 | 2000 Volkswagen Golf

1 Answer

Code fault po600 on my vw golf 1.6 automatic


I don't see a P0600 but you can check here at Ross-Tech.

Apr 06, 2010 | 2004 Volkswagen Golf

1 Answer

2002 vw passat....starts fine and drives fine....periodically stalls when braking for stop..this happens after a few miles of driving and is hard to get going again but will start and if reved up a bit I...


It appears that your brake booster system has a major vacuum leak which is causing the engine to go lean and stall. Check the hose between the intake manifold and the brake booster. It may be cracked or loose causing outside air to enter the hose when the brake is applied.

Jan 08, 2010 | Volkswagen Passat Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,666 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...