Question about 2004 Land Rover Range Rover

Open Question

2003 range rover door lock problems remote do not work

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 54 Answers

SOURCE: 2003 range rover power door locks do not work...

does the roof lamp work? if not then means your Vehicle in transport mode. to have it in normal mode you need to take it to a dealer or something equivalent to have the job done by approved diag. machine

Posted on Jul 06, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you enable a range rover engine when key battery is flat


There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!

Jul 14, 2014 | 2000 Land Rover Range Rover

1 Answer

I own a '99 Range Rover 4.6 hse. I recently reinstalled a battery that had gone dead. I cranked the engine but the alarm went off and the vehicle did not start. I am getting this message: gearbox fault. I...


Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke

May 21, 2010 | 1999 Land Rover Range Rover

1 Answer

2003 range rover power door locks do not work


does the roof lamp work? if not then means your Vehicle in transport mode. to have it in normal mode you need to take it to a dealer or something equivalent to have the job done by approved diag. machine

May 19, 2010 | 2004 Land Rover Range Rover

1 Answer

2003 RANGE ROVER DRIVER DOOR PROBLEMS.


replace the driver control modul on door

Aug 27, 2009 | 2003 Land Rover Discovery

1 Answer

Auto door locks no longer work with the remote.


if the locks work ok from the door manual switch then u have no fuse problem and may nedd to either install new batteries in the remote or if u have done that re-program them.

Mar 24, 2009 | 1995 Land Rover Range Rover

4 Answers

1996 4.0 Range Rover won't unlock


This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.

there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.

or if this too troublesome you can ask landrover dealer to remove the KEYCODE.

happy trying.....
adrian/kk.

Jan 10, 2009 | 1996 Land Rover Range Rover

1 Answer

CENTRAL LOCKING


Check your remote batteries.Listen for any sounds coming from the passenger door lock when operating the drivers door switch.The lock could be faulty.Have a diagnostic check done at a dealer to tell you whats wrong , this is normally free , before stripping anything..

Jun 23, 2008 | 1998 Land Rover Range Rover

Not finding what you are looking for?
2004 Land Rover Range Rover Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...