Question about Cars & Trucks

1 Answer

2001 pontiac montana 3.4 trouble code p440

On the road in a sudden the motor cut off three to for time in second thnrun good again

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Filmmaker:

    Uploaded 5 video answers.

  • Expert
  • 104 Answers

Thats a evap code should not turn the car off you are heaving some other issue

Posted on Dec 02, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Help me with a motor interchange

to change from the grand am to fit montana u have to change upper an lower intake wiring harness for fuel inj differant and front timmig cover all said an doneiwould keep to a 2001 if possable 1999 an 2001 are odd yrs

Posted on Mar 31, 2009

  • 1 Answer

SOURCE: My rear left tire of 2001 Pontiac Montana will not turn

i just had to replace a leeking wheel cylinder due to this same problem wheel would not release

Posted on Aug 14, 2009

  • 491 Answers

SOURCE: 2001 Pontiac Montana trouble code P1133 ???

P1133 .......Oxygen sensor bank 1 sensor 1.

Posted on Aug 27, 2009

  • 4044 Answers

SOURCE: 2001 jeep cherokee 4.0l won't start; good crank

303 is a misfire on the number 3 cylinder, 432 is a bad catalytic converter or O2 sensor, 456 is a minor evaporator leak (Most likely the gas cap wasn't screwed on tight). Do a compression check on the motor. Most likely you'll find zero compression or low compression on 1 or more of the cylinders. I suspect your timing belt broke. Unfortunately this means you be replacing the timing belt but you will also have to have the head fixed and replace all of the valves. If the vehicle has a Distributor and not a coil pack you can remove the distributor cap and crank the motor over, if the rotor doesn't turn it is you timing belt, if it does the timing belt is good. Some vehicle also have a plastic cover over the front timing belt pulley that can be removed to check the belt. You maybe able to remove this and check it that way.

Posted on Jul 17, 2010

  • 1 Answer

SOURCE: how unlock a radio for pontiac montana 2001

you need a unlock code from a gm dealer

Posted on May 30, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The radio in my 2000 Pontiac Montana says locked


1. Turn the ignition ON (The radio should display "LOC")
2. Hold down the Radio Presets 2 and 3 buttons for six seconds
3. The radio display changes from LOC to a three-digit number. Write this number down. You now have fifteen seconds to complete the next step.
4. Press the AM/FM button
5. The radio display changes to another three-digit number. Write this number to the right of the first one.
6. You now have a six-digit number, the first three digits are from STEP 03 and the last three digits are form STEP 05
7. Call 1-800-537-5140 (talk to a machine)
8. Press 1 then # (pound). You'll hear "Invalid Code, try again"
9. Press 139010 or 106010 or 206010 or 202107 then # (pound). You will be asked to enter your four or six digit code followed by *
10. Enter the number from STEP 6 then *
11. Listen to the four-digit number and write it down. It will be repeated twice
12. Turn the ignition ON (The radio displays LOC)
13. Use the MN and HR buttons to enter the code from STEP 11
14. Press the AM/FM button. The radio display changes to "SEC". Your radio is now "un-locked" and usable.
15.



Dealership Codes
202108
206053
620529

Sep 23, 2014 | 2000 Pontiac Montana

1 Answer

My pontiac 2003 montana will start fine,while driven on the road,the car just stops. three minutes later I starts it up and it rides,go a few miles and does it again. Can you tell me what the problem


The engine in this car is controlled by a computer, whenever a problem like this occurs you must have the electronic engine control computer checked for fault codes as the 1st step in diagnosis and repair of the problem.

Feb 21, 2012 | 2003 Pontiac Montana

1 Answer

Windows problem


I purchased a 2001 Pontiac Grand AM GT in March 2001. Since that time, I have had three windshields, and all the window motors/regulators replaced. Now I need to have the windows repaired again. I have been the only driver of this car, and have less than 69,000 miles. How do you get Pontac to fix this? I cannot afford to replace again, since I am trying am no longer receiving a pay check, and have applied for disability. Thank you, Linda

May 26, 2010 | 2001 Pontiac Montana

1 Answer

How do you know if you need to change a fuel filter in a 2001 pontiac montana or if the injectors are bad? If i can heard my fuel pump running does it mean it's still good?


UR OWNERS MANUAL WILL LET U KNOW. ALSO, IF U EXPERIENCE STALLING OR HARD START PROBLEMS.
INJECTOR TROUBLES ARE GENERALLY POOR MILEAGE, MISFIRING, HARD STARTING.
MANY IN TANK FUEL PUMPS U CAN HEAR WORKING, GENERALLY WHEN U TURN TO KEY ON. ONCE U HAVE THE MOTOR RUNNING, U MAY NOT HEAR THE PUMP RUNNING. IF U DO, I WOULD HAVE IT LOOKED AT.

Dec 23, 2009 | 2001 Pontiac Montana

1 Answer

Change oil message stays on even after repeatedly cancelling


Pontiac Aztek, Montana 2001-05 w/o (DIC) Driver Information Center; Torrent, Ascender 2006

Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. Turn the key to OFF If the CHANGE ENGINE OIL’ message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Pontiac Aztek, Montana 2001-06 wI (DIC) Driver Information Center

urn the ignition to ON, with the engine off. Press the MODE button until the DIC reads ‘OIL LIFE LEFT/HOLD SET TO RESET Press and hold the SET button until 100% is displayed. You will hear three chimes and the “CHANGE ENGINE OIL” message will go off. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Good luck

Nov 10, 2009 | 2001 Pontiac Aztek

2 Answers

2001 Pontiac Montana trouble code P1133 ???


P1133 .......Oxygen sensor bank 1 sensor 1.

Aug 27, 2009 | 2001 Pontiac Montana

2 Answers

How to reset the change oil light in a 2001 pontiac montana with a digital message center?


turn the key on to the power position but do not start the vehicle, then press the accelerator pedal to the floor three times within a ten second period.
Good luck dont forget to rate

Apr 01, 2009 | 2001 Pontiac Montana

2 Answers

Check Engine Light on and flashing on Montana 2001


You need to get the check engine light codes read. Until then you're just guessing when you replace parts. The engine light is on for a reason, it means there are stored trouble codes. Get those codes read and look them up here - http://www.obd-codes.com

Good luck!

Mar 23, 2009 | 2001 Pontiac Montana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75235 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...