Question about 2007 Suzuki XL-7

Open Question

How to replace headlights on a 2008 suzuki xl7

How do i gain access to the headlight itself

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: headlight

That's normal... your Suzuki comes equipped with DRL (daytime running lights). I thought the same thing until I found out it was normal for that happen. Hope this gives you clarity.

Posted on Mar 04, 2009

  • 1986 Answers

SOURCE: how do i adjust my

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 19, 2009

Testimonial: "thanks"

  • 1 Answer

SOURCE: how to replace headlight bulb in 2008 suzuki xl7?

http://www.suzuki-forums.com/2g-2007-xl7/19397-replacing-headlight-bulbs-2.html

Posted on Mar 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace headlight bulb in Suzuki xl7


unscrew the headlight bezel around the bulb and unplug then plug new one in,then replace the bezel and screws

Apr 22, 2015 | Suzuki Cars & Trucks

1 Answer

How do I change front side light bulb on 2008 Suzuki grand vitara?


the operators guide in the glove box lost? really>?
it covers all major bulbs (safety related) for sure this.
just $4 to read or DL
https://suzukipitstopplus.com/

ever google before, here, i will for yah

https://www.google.com/webhp?gws_rd=ssl#q=change+headlight+bulb+2006+suzuki+grand+vitara

Mar 01, 2015 | 2008 Suzuki Grand Vitara

1 Answer

How do i replace my headlight bulb in my 2005 xl7 suzuki


Reach into back of lamp holder and turn socket counter clockwise to remove. Install new bulb being careful to avoid skin contact to bulb.

Jun 21, 2014 | 2005 Suzuki XL-7

2 Answers

How do you remove the headlight assembly on a '96 Suzuki Sidetrack Sport


1.8L sport. USA ?
1: gain access to the rear of HL.
2: twist the European style, HL , lamp holder, and it unlocks
3: replace lamp.
if you want to replace the the HEAD LIGHT SHELL that is different.
remove grill, remove shell, replace shell, align lamps.
its all here
http://www.scantool.net/software/alldata-diy-1-month-subscription.html

Feb 09, 2013 | 1996 Suzuki Sidekick

1 Answer

How do I change a low beam headlight on a 2007 Suzuki Grand Vitara


You will need to find access to the headlight. On some vehicals, the grille may need to be removed to gain access. Once access is gained, unscrew the light that needs to be replaced and replace it.

Apr 17, 2011 | 2007 Suzuki Grand Vitara 4WD

1 Answer

Need to replace headlight bulb 2007 hhr


H13 HALOGEN HEADLIGHT BULB, SOLD INDIVIDUALLY -- Low 55/high 65-watt halogen bulb; 12.8 volts; P26.4t base; A high quality, direct fit OE replacement headlight bulb

3c8c3dc.jpg


How to Replace a Headlight Bulb
(DIY Complexity: Easy / Time: 0.9 hour)

Parts:
1. Headlight Bulb

Tools:
1. Screwdriver
2. 1/4 in. Drive Ratchet
3. Socket Set

Steps:
Step 1 Open the hood and locate the headlight assembly.
o Tip: Most headlight assemblies have a place in the rear to gain access to the headlight bulb.
o Tip: It is recommended that headlight bulbs are replaced in pairs.
o Tip: Always make sure the struts on the hood can fully support the weight of the hood so that it does not close on you while working. The use of a hood prop can securely hold it in place.
o Tip: Safety Tip:Always wear safety glasses when working on your vehicle. Wear other personal protective equipment (PPE) when necessary, for example latex gloves or safety shoes.

Step 2 Gain access to headlight bulb.
o Tip: It is a good idea to check the high beam and low beam headlight bulbs at this time.

Step 3 Disconnect the wiring harness and replace the old headlight bulb with a new one.

Step 4 Turn on the headlights and check high and low beams to verify repairs.

Hope this help (remember rated this help). Good luck.

Mar 30, 2010 | 2008 Chevrolet Hhr

1 Answer

How to change headlight bulb, '06 Honda Accord drivers side?


remove a few of the clips on the inner fender liner, depending on which bulb u are replaceing(left or right?) turn the wheels in either direction and u will be able to slide ur hand or arm between the liner and fender to gain access to the bulbs and connectors..do not remove the battery .

Mar 28, 2009 | 2008 Honda Element

1 Answer

Headlight


That's normal... your Suzuki comes equipped with DRL (daytime running lights). I thought the same thing until I found out it was normal for that happen. Hope this gives you clarity.

Nov 19, 2008 | 2003 Suzuki XL-7

1 Answer

How to replace headllight lamp


I know your frustration! I cannot believe the complexity of changing the headlights. Chevy has tried to make this a dealer item only just to change a headlight bulb. I will try to explain the procedure unfortunately I do not have photos. First you will need to remove the wheel well liner (two bolts and two plastic push pins). Pull the wheel well housing back (you will need to turn the wheel/tire to gain access) and using a 7mm socket remove the plastic support piece that holds the bumper in place (two bolts). Pull the corner of the bumper down until you can locate the bottom bracket of the headlight assembly that is held by a 10mm bolt. Remove it. (Oh did I mention this is a two person job!) Next move to the front of the vehicle (hood up) and remove all the 10mm bolts holding the upper part of the grill (I think there are eight of them). Now remove the obvious top two bolts on the headlight assembly! With two people - one to work the headlight assembly and one to push down the bumper and pull out on the grill assemble, slowly and carefully pull the headlight assembly straight forward. You will need to be mindfully of the small tabs on the headlight assembly that like to get caught on bumper/grill. If you are just replacing the bulb, you should be able to move the headlight assemble far enough forward to gain access to the bulbs without totally removing the headlight assembly. What a ***** job! SHAME on GM.

Oct 11, 2008 | 2008 Chevrolet Suburban

Not finding what you are looking for?
2007 Suzuki XL-7 Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...