Question about Cars & Trucks

Open Question

How can i download the free, wiring diagram manual of tata safari DICOR from internet

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
franktilt
  • 403 Answers

SOURCE: I need a repair manual, schematics,wiring diagram

autozone.com sign up its free then click on repair manuals you will find all of your info there....good luck

Posted on Jun 03, 2010

Ad
  • 239 Answers

SOURCE: where to get free download of audio wiring diagram

1996 Ford Explorer Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Green/Violet
Car Radio Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Light Blue/Red
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger: Orange/Blue
Car Stereo Amp Trigger Wire: Blue (If Equipped)
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Gray/Light Blue
Left Rear Speaker Negative Wire (-): Tan/Yellow
Right Rear Speaker Positive Wire (+): Orange/Red
Right Rear Speaker Negative Wire (-): Brown/Pink

pls rate

Posted on Aug 18, 2010

emissionwiz
  • 80407 Answers

SOURCE: where is throttle position sensor in my tata indica dicor?

It is mounted on the throttle body and is actuated off the throttle shaft.

Posted on Sep 20, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the front right door pad on a tata safari 2.2 dicor. thanks


please you see around pad screws and open screws first then pust up side then you will see it will be out thats it

Sep 24, 2017 | Tata Cars & Trucks

1 Answer

Tata safari 2.2dicor timing marks


I need help for tata bakkie dicor timing mark for head double cam ,diesel pump to crankshaft mark plz

Apr 09, 2014 | Cars & Trucks

1 Answer

In TATA Safari Dicor ,After starting My Car's Engine ,The Check Engine Indicator Blink's & the Vehicle Pickup Drop's When It get's On i just Wanted To Know weather it harm's my car's Engine much


That sounds like a problem that could become worse if ignored. It might also be a plugged fuel filter or bad O2 sensor. Get the codes checked and see whats needed to correct the problem.
Those are the two things i can possibly think may be wrong, wither something in the fuel system or a bad sensor.

Aug 12, 2013 | Cars & Trucks

1 Answer

Where is throttle position sensor in my tata indica dicor?


It is mounted on the throttle body and is actuated off the throttle shaft.

Sep 20, 2012 | 2007 Tata Indica Dicor

1 Answer

Tata indigo dicor trouble code p1200


what is thep1200 troble code in tata indigo cs dicor

Feb 10, 2012 | Tata Indigo Cars & Trucks

Not finding what you are looking for?

Open Questions:

0 Answers

2008 nissan altima a/c issues Last week the car stopped blowing cold air. After doing a pressure test, the low/high readings were both around 100. I assumed that the compressor wasn't kicking on. The compressor clutch had been working until this issue started but there was a noise that sounded like it was going bad. It had 100K miles on it so I replaced it. I also replaced the condensor (due to some damage on the front), the drier, and expansion valve. The only original component that showed a leak when I checked with my UV light was the drier....right at the based of the LP switch. After getting everything buttoned up i pulled vacuum on it for an hour and it held at 29". I then closed the valve and turned the pump off and let it sit for another hour. It was still holding at 29". I hooked up the freon to my manifold gauge and turned the car on with the a/c going. I charged the system until the low/high pressure was 37/190. The air was blowing colder about about 55 degrees. I thought it would be colder but it was an improvement. Once complete and everything disconnected, I turned the car off and went inside. I came back out a few minutes later and cranked the car....compressor wouldn't come on and warm air resumed. I ended up evacuating the system again and repeated the vacuum/recharge process again....cold air around 55 degrees. I reached over and turned the MAX A/C button on, the compressor went off and the warm air was back. I do not know if these two things are related but I also noticed that the condensor/radiator fans are not running at all. Could this be a sensor? Any help would be appreciated. I know enough about this stuff to be dangerous so if you give some tips, please simplify the best you can. Sometimes people give advice they forget that the little details stump us novices at times. ha. Thanks

Jul 18, 2018 | Nissan Cars & Trucks

Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15273 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...