Question about 2006 Mitsubishi Galant

Open Question

2006 galant will not start just cleaned the throttle body

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
franktilt
  • 403 Answers

SOURCE: Could you give me a diagram of a 2003 Mitsubishi

franktilt_3.pnggood luck

Posted on Feb 06, 2011

Ad
  • 56 Answers

SOURCE: can i use carburator cleaner on throttle body on

yes, do not use too much, i advise either remove thr throttle and clean out, then leave it off to dry out. or spay the carb cleaner into a rag and cleanout the trottle with the rag. if you use a lotof spary will be hard to get the engine started after and will blow out a lot of smoke. may run rough for a min or 2 until it burns out the carbon that this stuff will clean out.

Posted on Apr 03, 2011

  • 46679 Answers

SOURCE: I have a 1999 Mitsubishi Galant that sputters bad at 3,000 rpm. Only 130,000 miles. Just cleaned out mas air flow sensor n throttle body. What could be wrong

run the fault codes as what you have done may have no impact on the fault

Posted on Apr 14, 2015

paulmacin18247
  • 3218 Answers

SOURCE: Where is the throttle body located? How do we clean the throttle body?

Throttle body is located where the hose from the air filter box meets the engine. Big black hose. Remove this hose from the engine side and this will be the throttle body/plate assembly. If it is black/oily inside, clean with carb spray and a toothbrush to remove any dirt/deposits

Posted on May 02, 2015

georgethedea
  • 7 Answers

SOURCE: I have a 1999 Mitsubishi Galant that sputters bad at 3,000 rpm. Only 130,000 miles. Just cleaned out mas air flow sensor n throttle body. What could be wrong

Check timing belt to be properly line up to the markings or take it to someone who knows about this cars to check if its lined up ,I had a similar situation and it was out of timing and it started to not rev to the max and being very lazy on going up hills or just going up.

Posted on Nov 23, 2015

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Engine idles a little high when in drive


check hoses for vacuum leaks also throttle body may need to be cleaned and or throttle body position sensor can be starting to be faulty or may require cleaning with throttle body --the following links show how to clean a throttle body look up the ones that do it in /on vehicle you dont have to remove it from vehicle
How to Clean throttle body GM 3800 throttle Body Tune Up Cable accelerator... Throttle body cleaning and idle relearn procedure

Jul 27, 2016 | 2006 Buick Lucerne CX

1 Answer

I have an 03 Galant,my car idles between 625 to maybe 725. I have 143700 miles on it. What could be causing my low idle ?


How long since the last tune up and oil change ? If not over due clean or replace the air and fuel filter, clean out the throttle body. the idle speed can be adjusted at the throttle body.

Dec 15, 2015 | 2003 Mitsubishi Galant

1 Answer

Where is the throttle body located? How do we clean the throttle body?


Throttle body is located where the hose from the air filter box meets the engine. Big black hose. Remove this hose from the engine side and this will be the throttle body/plate assembly. If it is black/oily inside, clean with carb spray and a toothbrush to remove any dirt/deposits

May 02, 2015 | Mitsubishi Cars & Trucks

1 Answer

2006 chevy malibu wont start unless i hit the gas pedal


it will be a good idea to clean injector. It's a good thinking to clean throttle body......never forget for good combustion you need AIR,good FUEL,and good spark
when you need to crack up the throttle plate to start means throttle body dirty and IAC valve dirty or not working properly
hope it helps

Mar 30, 2014 | 2006 Chevrolet Malibu LT

1 Answer

How to clean a throttle body on a 2006 gmc envoy


take your air snorkel tube off at throttle body and pull back out of way, then take a rag and soak with throttle body cleaner, carb cleaner, or brake clean...they all work well, then reach inside the housing and open throttle plate and start rubbing the gunk off inside the throat of throttle body and throttle blade till all is clean, will take several times to get all clean. when all done put snorkel back on BEFORE starting vechile or you will have a service eng. soon light.

May 20, 2012 | 2006 GMC Envoy Xl

1 Answer

Can i use carburator cleaner on throttle body on 2004 mitsubishi galant


yes, do not use too much, i advise either remove thr throttle and clean out, then leave it off to dry out. or spay the carb cleaner into a rag and cleanout the trottle with the rag. if you use a lotof spary will be hard to get the engine started after and will blow out a lot of smoke. may run rough for a min or 2 until it burns out the carbon that this stuff will clean out.

Mar 29, 2011 | 2004 Mitsubishi Galant

1 Answer

Have a 1996 Mitsubishi Galant and need intstuctions on how to replace the Idle Air Control Valve


You'll have to remove the throttle body to replace the idle air control (IAC) valve. First, disconnect the negative ground cable from the battery. Then remove the vacuum line and air duct intake. Then disconnect the IAC and throttle position sensor (TPS) electrical connections. Remove the coolant hoses that are connected to the IAC. Disconnect the throttle cable from the throttle body. Now, remove the 4 bolts that hold the throttle body to the manifold and remove. Be careful with the gasket located between the throttle body and manifold and replace it in the same position. On your clean work surface, turn the throttle body over and remove the 4 phillips head screws holding the IAC to the throttle body. Clean the parts with a dry cloth but do not use solvents on the IAC or TPS. That's it!

Dec 16, 2010 | 1998 Mitsubishi Galant

1 Answer

2006 Envoy stalling when idels and won't stay running


Clean your Throttle body and pay attention to the Idle Air Control (IAC) valve passageway to try to clean the IAC. A dirty or faulty IAC will cause your engine to stall at idle, the job of the IAC is to open the passage way through the throttle body to regulate the amount of air to enter the engine to keep it from stalling when the Envoy is at idle.

Start with the simple and clean the throttle body and inspect any loose or damaged wire leads to the throttle body. Replace or repair any signs of damage.

Thank you for using Fixya and good luck.

Apr 10, 2010 | 2006 GMC Envoy Xl

1 Answer

2001 Galant won't stay on.


Looks like gum and carbon deposits have clogged some critical parts in the engine, such as injectors.
You would need to get to the 'throttle-body'.
1. Trace the big intake-air hose to where it ends on top of the engine. This is the throttle -body.
2. Loosen the clamp that's holding the big-intake air hose. Pull off the intake air hose from the throttle-body.
3. Spray some "Throttle Body & Carburettor cleaner into the throttle-body. You could use the entire can.
4. Wipe off excess gas from the throttle-body with a piece of rag.
5. Reconnect the intake air hose, and check if the
problem has disappeared.

Dec 16, 2009 | 2001 Mitsubishi Galant

1 Answer

2006 scion TC Hard starting


Does it start if you give it gas when turning the key? I had a grand prix that would not want to start unless I gave it gas. It was an easy fix. I changed the air filter, used MAF cleaner to clean the MAF and I also took the throttle body apart and cleaned that. The throttle body had a black build up in it that I cleaned up with throttle body cleaner.

Nov 01, 2008 | 2006 Scion tC

Not finding what you are looking for?
2006 Mitsubishi Galant Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...