Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
its probally a haligen bulb needs replaced from the inside under the hood that twists in the back of the light just half a turn the unplug old and put in new
Posted on May 31, 2009
If the ground is good I would take a careful look at the light socket itself. There may be corrosion inside or on the power wire where it goes into the socket or it may just be making poor contact.
You can get a replacement one at any auto parts store. The last one I got was about $10. Get some heat shrink tube to cover your splices, it does a much better job of sealing the splice than tape. Hope this helps.
Posted on Aug 14, 2009
quite simple you most likly have a broken earth/netural wire broke check it out .adrian;;;
Posted on Nov 08, 2009
Testimonial: "Thank you. I will check the grounds and harness for breaks."
The driver side headlight is dim. This is caused by loose
ground contact of the headlight ground terminal. Have
a check on this by tightening it up or reconnecting to
good ground (chassis).
Posted on Nov 08, 2009
I have run into a few of these and what I found was water getting into the wires that go to these headlights.The harness is just below the battery area.It will be easier to get to from the bottom of the vehicle.You will have to remove the plastic cover from the harness and the electrical tape.Find the dark blue and the orange wires.The dark blue is for the drivers side and the orange is for the passengers side.There should be 2 of each.Look real closely and see if you see a spot where the wires are slightly swelled up.These wires are only 18 gauge so it is not easy finding the bad spot.One thing you can try is pulling on the wires a little and sometimes they will separate where the bad spot is.Hope this helps.Good luck.
Posted on Dec 16, 2009
Tips for a great answer:
Dec 09, 2016 | Pontiac Cars & Trucks
Apr 04, 2016 | 2008 Pontiac G6 Sedan
Aug 24, 2014 | 2007 Pontiac G6
Feb 24, 2013 | 2005 Pontiac G6
Nov 09, 2011 | 2005 Pontiac G6
Jan 18, 2011 | 1997 Pontiac Sunfire
Oct 02, 2010 | 2005 Pontiac G6
May 31, 2009 | 2005 Pontiac G6
Mar 25, 2009 | 2006 Pontiac G6
Nov 21, 2017 | Cars & Trucks
84 people viewed this question
Usually answered in minutes!