Question about Cars & Trucks

1 Answer

Reditors dont get hot

The Boilers working fine but some rediators get hot and some dont

Posted by on


1 Answer

This is the automotive section

Home radiators?

Open the small bleeder on top & let out the air

Posted on Dec 02, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Chevy inpala rediator fans dont tern on rpm not working

The fan comes on only when engine has wormed up , the air con fan comes on with the air con. switch.

Apr 03, 2017 | Chevrolet Impala Cars & Trucks

1 Answer

Enjin over heating

when the enging is cool, remove the rediator cap and add water/antifreeze until it is full. you may need to start the car to get it full, then check it a few times after that. just dont open the radiator when the engine is hot. once the radiator is full put the cap back on and let the engine run until warmed up. look for any signs of a hose or the water pump leaking. that could be the reason for the overheating. replace any leaking hoses and or water pump. good luck ! Tim

Sep 16, 2012 | 2001 Mitsubishi Pajero

1 Answer

How can I resolve a eating problem. The temperature of the engine is always beetwen 90 and 96 degrees and I think that is ttoo hot for normal routing. Can change the thermostate? or chenge the rediator?...

If it is that low it is running too cold. Typical Operating temperature is 180 to 212 degree. Check your thermostat. If it's not boiling over or your temperature gauge is between the Hot and Cold marks on the dash indicator, close to the center between the two, then your engine is fine.

Oct 09, 2010 | Chevrolet Cavalier Cars & Trucks

1 Answer

Overheating after rediator replacement. Thermostat was replaced, fans working fine.

If you have more than 60k on the vehicle and
have never done a timing belt or water pump this is the time to do it.

Nov 09, 2009 | 2000 Toyota Camry

1 Answer

1995 Subaru Legacy Wagon Radiator

Hi sir, if you want to do a proper job here's how.
  1. Get radiator flush let you car Idle for a while or drive for 15 min.
  2. Let Car cool Down
  3. If no drain PLug remove the hose at the bottom this is the same pipe going into your water pump, Work gentle with it try not to damage the pipe.
  4. open your rediator cap, this will allow the water to train from radiator.
What about all the dirty water inside the engine? this is how to do a decent flush.

  • The car should be cold
  • remove the water pipe at the top of the radiator
  • take your garden hose and insert it to the rediator don't force it just hold it there.
  • Start the car let it idle, open the hose pipe.
What happens now is that the water pump pulls all the clean water trough the rediator and pushes all the dirty water out the other side.
  • when water is clear turn off water
  • kill engine
  • Tighten water hose
  • refill with good Anti freeze anti boil and top op with water
  • drive the car till hot
  • check for any leaks on the pipes you removed before
Hope this Helps

May 13, 2009 | 1996 Subaru Legacy

2 Answers


the drain plug is on the bottom of the rediator on the drivers side on the back side of the radiator.

Dec 31, 2008 | 2004 Dodge Stratus

2 Answers


check all the cooling running. rediator, upper and lower water hose, heater cord. You have Block or a leak.
no cooling return from the engine block.

Oct 29, 2008 | 1994 Lexus GS 300

1 Answer


first thing you have to see,fan is on or not after reach tomprature 190 f if the fan turn on check water pump situation not loose etc. after you go to thermostat,might stuck closed etc.if everything good
spray some water on rediator if tempreture go down then rediator problem,otherwise that above mention one of these.

Oct 20, 2008 | 1998 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13735 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides