Question about 2004 Kia Sorento
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The above information about the sensor being located at the top of the motor to the passenger side of center is bogus. That is only the pig tail plug in. The actual sensor pig tail continues down below, underneath the plastic lower timing belt cover, on the front of the motor, just above the crankshaft timing gear.
It is a very involved process of removing and replacing. You will have to remove all of the belts, the front timing belt covers, (upper and lower). You will also have to remove the front bracket that is mounted to the front of the block, which serves as the mount for the power steering pump, the alternator and the A/C compressor.You will also have to remove the crankshaft pulley. You cannot remove the plastic lower timing belt cover unless you remove all of these things first. The sensor is located underneath the lower cover. It has two bolts that hold it in place. You will have to remove these two bolts.
The crankshaft pulling bolt is a right handed thread and loosens by turning counter clockwise. The pulley will slip off but is a very tight fit. Do not try to turn it while removing it as there is a small pin that keeps it aligned to one position. Use a small ball pine hammer to tap it loose.
It is also a good idea to remove the electric cooling fan shroud that is mounted to the inside side of the radiator and the radiator hoses to give yourself more room to work. It has only two bolts at the top holding it in place. And then slips into two retaining clips at the bottom. Lifting it will pull it out of these retaining clips.
When you remove the small bypass hose located at the top of the radiator , to the passenger side, be careful not to break off the small nipple protruding out of the radiator tank. It is plastic and will break easily if you try to pull the rubber bypass hose from it. This will have to be taken to a radiator shop to have repaired if you accidentally break this off. Be sure to carefully loosen the hose from this nipple before trying to pull it off.
And one more thing, if you go to that much trouble to replace this sensor, it is a good idea to go ahead and replace the timing belt as well. It is a maintenance item and you will have to go through the same process to replace it as well. Do it once and do it all.
I hope this helps.
Posted on Nov 15, 2008
Be careful there.. If you remove the Throttle Position Sensor TPS or the throttle Cable, the engine light will come on because there is a certain setting that needs to be done to ensure accurate emission control.
Posted on Apr 14, 2009
THE KIA SORENTO HAS 3.3 AND 3.8 ENGINES THEY HAVE TIMING CHAINS.THE KIA 2.4 ENGINES HAS TIMING BELT GUIDE PLATE.
Posted on Jun 21, 2010
Tips for a great answer:
Oct 31, 2016 | 2004 Kia Sorento
Nov 01, 2014 | 2004 Kia Sorento
May 16, 2014 | 2004 Kia Sorento
May 25, 2011 | 2004 Kia Sorento
Apr 04, 2011 | 2004 Kia Sorento
Jul 24, 2009 | 2004 Kia Sorento
Apr 28, 2009 | 2004 Kia Optima
Apr 04, 2009 | 2006 Kia Sorento
Jan 09, 2009 | 2007 Kia Sorento 4x4
Nov 23, 2008 | 2007 Kia Sorento LX 4x4
61 people viewed this question
Usually answered in minutes!