Question about Cars & Trucks

1 Answer

I have a 2003 mazda 6 and the when the car is off its draining the batt what could be the cause

Posted by on

1 Answer

You have to put an amp meter in series in either battery cable
& check for current draw with doors closed & give it 20 min for
things to time out.

If you open a door you have to start over

If you have over 60 milli volts then you start pulling one fuse at
a time to find the circuit that has the offender on it

Need wiring diagrams for that also

Posted on Dec 02, 2012

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 41 Answers

SOURCE: need to change headlight on 2003 mazda rx 6

If it is the headlight itself. There may be a cover or shroud on the front of the engin bay. Remove that, may be a combination of clips and screws. If it does not cever the light area, it is even easier. There will probably be 3 screws or nuts, remover these and unplug the electrical to the light. From there you should just be able to pop the light out of place. If you are just replacing the bulbs. Where the power goes into the assembly, turn the clip, may be grey in color and pull out of the headlight assembly and replace the light bulb. But don't touch the new bulb the oils from your skin will damage the bulb.

Posted on Apr 22, 2009

  • 104 Answers

SOURCE: whats wrong with my car remotes? 2003 mazda 6

sounds like keyless entry module failure or PJB box failure wiring check required

Posted on Oct 20, 2009

  • 1297 Answers

SOURCE: Anyone know where the a/c

on the "firewall" now called the bulkhead
on the passenger side
near the bend where the bulkhead becomes the floor

Posted on Aug 31, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What can cause a whining noise coming from 2003 mazda 6 engine?

That is commonly caused by a power steering pump issue, it is either low on fluid due to a leak in a hose or the pump is defective.

Oct 06, 2016 | Mazda Cars & Trucks

1 Answer

Got a code p0316 on a 2003 mazda tribute

Bad spark plug and/or plug wire

Nov 23, 2013 | 2003 Mazda Tribute

1 Answer

Changing points on mazda 6

This WEB site has ignition parts for the Mazda 6

Apr 05, 2013 | 2003 Mazda 6

1 Answer

2003 Mazda 6, 4 cyl has erratic idle. Idle will

M.a.P. sensor, air leak in intake system, low or erratic fuel delivery

Jul 11, 2010 | 2003 Mazda Mazda6

1 Answer

I have a 91 mazda mx6 it will turn over but will not always fire up,but when it does it may run for a long time or it may die rite away and then sometimes it'll start up and sometimes I can crank the batt....

Check the air intake tube that goes to the throttle body, Check for cracks or leaks, This can cause unmetered air to get by the mass air flow sensor

Mar 13, 2010 | 1991 Mazda MX-6

2 Answers

Mazda 6 2o diesel replaced turbo new unit same

There is a oil drain return from the turbo charger to the sump. If the sump oil level covers the outlet into the sump, oil will build excess pressure tin the turbo causing the sealing rings to leak oil in to the intake manifold. This would cause smokey exhaust and loss of oil. Try this. Drain the sump completely, refill with the exact quantity of oil to Mazda spec. Dip the oil and if the new oil level is lower than the full mark on the dipstick, you have found the cause of the problem. Mark this new level with a scriber or file and fill only to this new level. Hope this is the solution.

Jan 28, 2010 | 2004 Mazda 6

1 Answer

Mazda 6 2001, IBS and handbrake warning lights keeps coming on

Check brake fluid level.  If fluid level is low, it can cause lights to flicker on and off while driving.

Nov 12, 2009 | 2003 Mazda Mazda6

1 Answer

Loud acceleration noise in my 2003 Mazda 6 2.0 auto

one thing to check is rear engine mounting i have had a stone wedged in one and it causes a nasty noise when accelerating

Apr 12, 2009 | 2003 Mazda Mazda6

1 Answer

Mazda 6 power problem

has the aircon just been regased i have had one over filled with 134a causing lack of power

Apr 06, 2009 | 2003 Mazda Mazda6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides