Question about Cars & Trucks

1 Answer

Location of the bcm on a 2002 chrysler town and country mini van

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

Sending a video

Posted on Dec 01, 2012

  • 1 more comment 
  • Christine Remsik
    Christine Remsik Dec 01, 2012

    i cant see your answer

  • teds repairs
    teds repairs Dec 01, 2012

    I sent you a video . showing you how to remove it and relace it .see if i can sentd it again. this is the link to my garage I am on facebookhttps://www.facebook.com/TedsRepairs

  • teds repairs
    teds repairs Dec 02, 2012

    see is this works

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: My Chrysler Town and Country

Did you try inserting the key in the drivers side door and locking and unlocking it manually several times to reset the alarm system. This was the problem with my 1996 Chrysler Town & Country LXI

Posted on Nov 02, 2008

  • 76 Answers

SOURCE: 2002 Chrysler Town and Country

Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug

Posted on Nov 18, 2008

  • 117 Answers

SOURCE: 2005 crank position sensor location

The crank shaft sensor on that model should be on the driver side towards the back of the tranny its not hard to get to.

Posted on Jun 27, 2009

  • 1 Answer

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?

Posted on Jan 28, 2010

  • 518 Answers

SOURCE: What does code p0032 mean in a 2004 chrysler town

Heater control circuit high, bank 1 sensor 1. Sounds like your O2 sensor in bank 1 in front of your convertor is bad.

Posted on Sep 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Blinkers don't work at all. Where can I find the fuse or relay? I'm very frustrated. I need help.


Chris, fuse could be down under the dash to the left kind of near where your left knee would be when you are driving or under hood (engine compartment) in the fuse/relay center.
It could also be faulty flasher, wiring, etc
I will post some trouble shooting links for you.
Press the helpful button.
1996 2000 Chrysler Town and Country Interior Fuse Check 2000 Chrysler Town...

How To Install Replace Taillight and Bulb Chrysler Town Country 04 07...

Fuse Box Location in 1999 Plymouth Grand Voyager Van

Quick Tip Signs of blown IOD Fuse on Chrysler Dodge Jeep Fiat or Ram...


Feb 15, 2016 | 2002 Chrysler Town & Country

1 Answer

What is causing misfiring?


Part 1 -How to Test the Coil Pack (2001-2008 Chrysler 3.3L ...

easyautodiagnostics.com > Chrysler > 3.3L, 3.8L
Apr 29, 2011 - Page 1 of 7: How to Test the Coil Pack (2001-2008 Chrysler 3.3L, 3.8L). ... ignition coil pack on your 2001-2009 Chrysler (or Dodge) 3.3L or 3.8L Town and Country, .... 3.3L or 3.8L Chrysler mini-van, are OK and not the cause of the misfirecondition. ... 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009.

Nov 14, 2015 | 2003 Chrysler Town & Country

1 Answer

Need to replace back hatch on 2002 crysler town and country


Unhook the props and wiring and get two people to help as it is very heavy.

Sep 28, 2014 | 2002 Chrysler Town & Country

1 Answer

Orifice tube


It is located inside the air conditioning hose where it connects to the evaporator, some are replaceable some you have to buy the whole hose when it goes bad.

Apr 08, 2014 | 2002 Chrysler Town & Country

1 Answer

The a/c was working but now it only works on high. How can this be fixed? I have a 2002 Chrsyler Town and Country mini van.


The blower only works on high? If so it sounds like you need a new blower motor resistor/module. It will be located on the passenger side behind the glove box.

Jul 16, 2011 | 2002 Chrysler Town & Country

1 Answer

2002 Chrysler Town and Country Rear Heat/Air only on High


most of the time the resistor is located downwind of the blower motor so it should be not to fao from the blower motor in the right rear of the van behind the quater trim panel which is the hvac unit is located

Jun 01, 2010 | 2002 Chrysler Town & Country

1 Answer

Describe your 2002 Chrysler Town &


On the driver side of the intake plenum close to the throotle body is were your pcv valve is located :)

Aug 23, 2009 | 2002 Chrysler Town & Country

1 Answer

My Chrysler Town and Country Mini- Van won't stay started


Did you try inserting the key in the drivers side door and locking and unlocking it manually several times to reset the alarm system. This was the problem with my 1996 Chrysler Town & Country LXI

Sep 28, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...