Question about 1996 Honda Civic
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the main relay may need to be replace. is the car hot inside on a hot day , and when you air out the car to cool inside temperture, it starts.
Posted on Dec 21, 2008
SOURCE: 2002 Civic trouble code P1298
Usually what causes this code is a blown fuse from the wiring harness shorted on the underside of the intake manifold. It usually rubs on the brace or the bottom of the intake and shorts out a wire and blows a fuse. Do you have any other codes? If so post them. Check this first and tell us which fuse is blown in the fuse panel.
Posted on Apr 19, 2009
Bearings are pressed into the hubs...much easier, faster and economical (if you don't have a press) to replace the complete bearing/hub assembly, no pressing is needed, since bearings are already pressed into the new hubs. Cost..aprox, 60 buxs each.
Here are the steps for the rear replacement...
Loosen the lug nuts on a rear wheel. 2) Chock the wheels and jack the rear of the car on the side with the lug nuts that you just loosened. 3) Remove the wheel by removing the lug nuts. 4) Pry open the dust cap covering the center of the axle/spindle. A small screwdriver tapped into the space between the hub and dust cap will work well for this. 5) With the dust cap now removed, use a thin center punch to straighten the little dent in the rim of the spindle nut so that you will be able to turn it freely in the next step. 6) Use a 32mm socket and a large breaker-bar to loosen the spindle nut. Unscrew the nut all the way and place it in a clean, safe area. 7) You should now be able to slide the hub/bearing assembly from the shaft. 8) Installation is the reverse of removal. Use plenty of high-temperature wheel bearing grease on all surfaces before you mount the replacement hub assembly.
IMPORTANT: Torque the spindle nut to 134 ft/lbs....(per manual specs)
When reinstalling the dust caps, tap them gently into place to avoid denting them...Install wheels, jack her down and pat yourself on the back...job complete.
Good luck..hope this will fixya up...please take time to leave me a fixya rateing...
Posted on May 23, 2009
check the oil and make sure it's NOT black, Check air filter, oil filter, and gas filter, check engine fuse, see if spark plugs are ok, check starter, check alternator and belt. if problem still persists please contact me at firstname.lastname@example.org
Posted on Jun 24, 2009
Tips for a great answer:
Aug 09, 2016 | Honda Cars & Trucks
Jan 17, 2015 | Honda Cars & Trucks
Dec 16, 2014 | 1994 Honda Civic
Apr 17, 2013 | 2001 Honda Civic
Dec 21, 2017 | 1988 Honda Civic 2 Door
May 16, 2009 | 2006 Honda Civic Hybrid
Oct 08, 2008 | 1996 Honda Civic
Jul 14, 2015 | 1996 Honda Civic
83 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: