Question about Cars & Trucks

1 Answer

How do I remove a 2006 ford radio - Cars & Trucks

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 71 Answers

The video as well as the info provided is not very good. Look on each side of the radio, do you see 4 little holes (2 on each side)?
If so, then you have to have 2 pieces of stiff wire about 8"-10" inches long (a metal clothes hanger works well). Slide the 2 pieces of wire one in the top hole and the other one in the bottom hole and with a small screw driver that side of the radio will pop out, but just a little.

Repeat the process to release the other side, once both sides are released you can slide the radio out to disconnect the wires.

Now, if you do not have the 2 small holes on each side then the radio will be bolted or held in by screws and you must take the panel apart to get access to the retaining screws. The panel, (depending on which vehicle), should also pop out. But be careful not to break the panel. If it doesn't pop out, you may have to remove other panels to get access to any screws holding it all together.

hope this helps

Posted on Dec 01, 2012


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 4944 Answers

SOURCE: how do i remove the radio from my ford fusion+ 200...

Most answers are here for removing Ford radios

Posted on May 26, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

Removed my battery in my ford escape 2007 when i put the battery back the radio is asking for a code help please

It most likely that your radio has a Sirius account and it is looking for its #ESN number

The following link shows how to access the number in the Ford section of the page
Find Your Sirius Radio ID SiriusXM Radio

I hope this has been a help?

Jan 10, 2016 | 2006 Ford Escape

3 Answers

My battery ran dead on my Ford Focus 2006 ztech and now it's asking for a radio code any idea how I can get this?

Sometimes its on a sticker in the back of the drivers handbook. If you don't have that then get a radio removal tool, take it out, look on the details on the back and go online typing "Ford Radio Codes" and a host of companies will pop up. Select the cheapest one, follow the instructions, see if they carry your code, pay a couple of bucks and you should be OK. If not go to another site. These sites will tell you before you have to pay if they carry the code. Its not a gamble.

May 22, 2015 | 2006 Ford Focus

2 Answers

Het the serial number with out taking out the radio frod bantam 6000 cd

If you email the link they will send information about getting the serial number without removing the radio and can give you the radio code for your ford radio: FORD RADIO CODE United Kingdom Gumtree

Feb 21, 2015 | 2006 Ford Bantam 1.6i

1 Answer

How do i remove the face plate on the 2006 ford expedition

Should be tiny holes for your flat head screwdriver to slide into and pop it off.

May 08, 2014 | 2006 Ford Expedition

1 Answer

How do I connect Sirus XM for a 2006 escape using the audio cable? Does my radio have an input jack?

You will need to remove the radio and look at the rear for the input, if your radio doesnt have an input you can buy the kit to connect it to sirrus and instead of direct connect you can use a radio station to connect to sirrus,most newwer cars and trucks will come with an input but lower brand radios may not. the only way would be to remove the radio and check , dont reinstall radio if you plan on getting the adapt kit.

Dec 23, 2011 | 2006 Ford Escape

1 Answer

How to I remove a cd that is stuck in the player of my 2006 Ford Focus?

Generally, you will need to remove the radio/CD player from the instrument panel. Once you have it out, you can remove the sheet metal cover on the top of the unit. With the top off, you can get your CD out.

Aug 19, 2011 | 2006 Ford Focus

1 Answer

How do i remove the radio from my ford fusion+ 2006 model

Most answers are here for removing Ford radios

May 20, 2010 | 2006 Ford Fusion

1 Answer

How do i remove the radio in a 2006 ford F-250

yes the tool you need is two pieces of steel that fit into both sides of the radio, there should be two holes on either side...the wires push in and the radio should pop out

Apr 06, 2009 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides