Question about Cars & Trucks
Here's an older FixYa post that may help you:
But, here's a much more detailed list of instructions on how to do it:
Posted on Dec 01, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
Posted on Feb 23, 2009
should be a drain plug on tranny pan if changing it is easier to pull pan and change filter if not just have the fluid flushed less mess way easy
Posted on Aug 30, 2009
1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.
Posted on Nov 01, 2009
The first objective is to figure out which bulb you need. I had to replace the bulb for the largest light which was a Sylvania 3157. The next objective is to remove the dang plastic carpet holder/net clip. Recognize that it is a two part piece. Use a flathead screwdriver for leverage. Pry the cap off by levering the screwdriver in the slot on the holder. Then go behind the carpet and pinch the plastic pin still holding the holder in place. Next,pry off the while plastic pieces from the two bolt/nuts you'll need to remove (see manual). Remove the nuts and give the two screws a push from the inside so you can see how the whole light casing comes off. Pry it off from the outside. On the backside of the bulb holder, turn bulb base counterclockwise and gently remove. Pull bulb upward and replace. Do not touch glass on new bulb with your fingers (wear non-powdered rubber gloves). Make sure the bulb snaps in place. Follow these instructions in reverse. Smile, you just learned something new and saved yourself some easy money.
Posted on Jan 09, 2010
Tips for a great answer:
Sep 12, 2014 | Nissan Quest Cars & Trucks
Jul 05, 2014 | 2007 Nissan Quest 3.5 Minivan
May 18, 2014 | 2005 Nissan Quest
May 29, 2012 | Nissan Cars & Trucks
Jan 24, 2011 | 2005 Nissan Quest
May 31, 2010 | 2005 Nissan Quest
Feb 17, 2010 | 1999 Nissan Quest
Oct 19, 2009 | 2005 Nissan Quest
Oct 18, 2017 | Cars & Trucks
622 people viewed this question
Usually answered in minutes!