Question about 2001 Chevrolet Suburban

1 Answer

Fuse is blown controlling internal amp, where is fuse located

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 129 Answers

Under ya dash on the driverside of ya car. Or it can be when you open the door on the driverside on the dash itself. It also can be on the passengerside on the dash behind the door too.

Posted on Dec 02, 2012

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mn55ford
  • 1 Answer

SOURCE: My 2004 2500hd duramax hvac stopped working. I

Check with Gm dealer for factory assistance for faulty wiring and blower motor relay problems. Depending on mileage may be free fix.

Posted on Oct 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location alternator fuse


Hi Aaron, I'm glad to help! The alternator fuse you are looking for also runs the auto-shut-down relay. NOTE: If your vehicle starts a runs then this fuse is good. If the vehicle will not start and runs then its FUSE 3 a 20 amp fuse inside the power distribution center under the hood. NOTE: Next you'll want to check the FUSEABLE LINK. This link attaches to the battery cable its a big GREEN colored wire. If you can grab the wire and it stratches while your pulling it, then it need to be replaced. CAUTION: If this wire is blown, then you need to replace the alternator as well for a dead short internally. If both of these or good, the only other option would be the Engine Controller. NOTE: Before replacing the Engine Controller, take the alternator off and have it check at the auto-parts-store. Most of the time its the alternator and not the engine controller. Hope this help and have an awesome day Aaron.

Apr 12, 2014 | 2000 Dodge Grand Caravan

1 Answer

Fuse for tail lights 2011 honda odyssey


The tail lights in your 2011 Honda Odessey are computer-controlled. The fuse that protects the tail lamp circuits is FUSE Number 22, located in the underhood fuse and relay box located in the right rear of the engine compartment. It is a 10 Amp fuse. There is also a tail light relay located in the same box.

Please NOTE: If the fuse is blown, the cause of the fuse blowing MUST be located and repaired. Simply replacing the fuse will only result in another blown fuse.

Also, relay failures are pretty rare. If you can find another relay in the relay box with the same part number on it, you can swap them to see if this helps.
If this does not get your tail lights working, you will have to scan your computer network for possible fault codes in order to locate the cause of the problem (which is really a good idea to BEGIN with).

Nov 19, 2011 | Honda Odyssey Cars & Trucks

1 Answer

What fuse is speed control


First, Please review these articles:

Where's The Fuse?

What Else Could Be Wrong?

Then to answer the question you asked...

There are actually three fuses involved in your cruise control system.

> The first is the "Cruise Control, EAT ECU" fuse. it is Fuse #4 in the Underdash Fuse And Relay Box. it is a 7.5 Amp fuse. This fuse also powers the gauge assembly, the alternator control circuit, the Radiator Fan Control Module, the Intake Air Bypass Control Solenoid Valve, The EGR Control Solenoid Valve, The EVAP Canister Bypass Solenoid Valve, the EVAP Canister Vent Control Solenoid and the Heated Oxygen Sensor Heater circuits. If this fuse is blown, the engine will not idle, The alternator will not charge the battery and the transmission will not shift properly. In general, a whole bunch of stuff will not be working.

> Next is the "Backup, Metering Lights, Turn Signals" fuse. It is Fuse #1 in the Underdash Fuse And Relay Box. It is a 10 Amp fuse. As you can tell by the description, your backup lights, dash warning lights and turn signals will also not be working if this fuse is blown.

> Last there is the "Stop Light, Horn" fuse. It is Fuse #30 in the Underhood Fuse And Relay Box located at the right rear of the engine compartment. It is a 20 Amp fuse. As you might guess, your horn and stop lamps will also not be working if this fuse is blown.

Jun 04, 2011 | 1995 Honda Accord

1 Answer

Where is the fuse for the trunk latch


First, please read this article: Where's The Fuse?

Then to answer your question...There are actually 3 fuses involved...
Your trunk release is controlled by the Theft Deterrent And Door Lock ECU. The three fuses that can affect your trunk release are:

1. ECU-IG fuse (15 Amp)
2. CIG fuse (15 Amp)
3. POWER fuse (30 Amp)

These are all located in Junction Block #1 on the left side of the dash.
If any of these fuses are blown, there will be a bunch of other stuff also not working.

Apr 02, 2011 | 1996 Lexus ES 300

1 Answer

Where is the fuse for a 2005 honda odyssey rear wiper


First, please review this article: Where's The Fuse?

Then to answer the question you asked:
There are actually 3 fuses involved in your rear wiper system.
They are all located in the driver's fuse/relay box located under the left side of the dash.
Fuse #7, 7.5 Amp
Fuse #21, 7.5 Amp
Fuse #30, 20 Amp
These same three fuses, if blown, will also have the symptom of the front wipers not working. So if the front wipers are working, the problem has nothing to do with a blown fuse.

There are also several control units involved in making the rear wipers work:
There is the Combination Switch Control unit, the MICU Rear Junction Box Control Unit, and the Relay Control Module. These are also powered (protected) by the fuses listed above.

I would recommend Obtaining a scanner and scanning the Controller Area Network (CAN) in your vehicle to see if there are any fault codes that can help you determine why your rear wipers are not working.

Feb 27, 2011 | 2005 Honda Odyssey

1 Answer

Shorted out one of the fuel injector wires,and now my fuel pump isn't working,checked the fuses,none are blown,any ideas,other fuses or fuse link?thanks,


The fuel injectors receive their power from the Powertrain Control Module (PCM) Power Relay which is located in the Engine Compartment Fuse Box. This circuit is protected by Fuse "I" (20 Amp), also located in the Engine Compartment Fuse Box. If you blew a fuse, this would be the one.
The fuel pump, however, is a totally different circuit. (although it is controlled by the PCM which will not work if the fuse above is blown) The fuel pump gets its power from the fuel pump relay which is protected by Fuse "O" (20 Amp) in the Engine Compartment Relay Box.

Jan 30, 2011 | 1994 Ford Bronco

1 Answer

My interior lights & remote just stopped working


Can be a blown fuse, Check your owner manual for the appropriate fuse that refer to what it is for such at lights, radio etc... and the location of where the fuse in located. Once you find that out, pull the fuse out to see if the fuse is blown, if it is blown replace it with the correct fuse amp. Sometimes there are couple of fuse that are reference to the same details too.

Jan 14, 2011 | 2006 Toyota 4Runner

1 Answer

Internal Control Module Keep Alive Memory (KAM)


P0603 means Internal Control Module Keep Alive Memory (KAM) Error

In other words, that code is set when the PCM loses "keep alive" memory B+.

This code can also be set if the batteries went dead at some point, but mainly it means there is an open circuit detected in the KAM circuit.

On a '97 F-250, check for a 5 amp fuse blown in fuse cavity #2. If the fuse is blown, check for and repair the short-to-ground in circuit #729 (red with white coloured wire).

Good luck dear.

Rate this.

Jan 24, 2010 | 2004 Honda Accord

1 Answer

FUZE BOX DIAGRAM FOR 1990 MERCURY TOPAZ


Replacement
  1. Access the fuse panel from the left of the steering column.
  2. Locate the blown fuse and pull out. DO NOT TWIST.
  3. Take note of the ampre number written on the top of the fuse. To install:
  4. Push a new fuse of the same ampre into the receptacle, making sure the contact is being made on both sides of the fuse.
LOCATIONS Headlights and Highbeam Indicator
  • One 18 amp circuit breaker (22 amp in 1987 vehicles) incorporated in the lighting switch.
Front and Rear Marker, Side Parking, Rear and License Lamps
  • One 15 amp circuit breaker incorporated in the lighting switch.
Windshield Wiper
  • One 4 1⁄2 amp circuit breaker located in the windshield wiper switch.
Power Windows
  • Two 20 amp circuit breakers located in the starter relay and the fuse block.
Power Seats and Power Door Locks
  • One 20 amp circuit breaker located in the fuse block.
Hazard Flasher REMOVAL & INSTALLATION NOTE: The hazard warning flasher is located on the rear side of the fuse panel.
  1. Locate the hazard flasher in the fuse panel.
  2. Pull the flasher out. DO NOT TWIST. To install:
  3. Push new flasher into place making sure a good contact is made with both terminals.
  4. Test flasher to make sure they function properly.
Various Relays LOCATION Cooling Fan Controller
  • Located behind the left side of the instrument panel.
Cooling Fan Controller Module
  • Located behind the right side of the instrument panel.
Cooling Fan Relay
  • Located in the air conditioning cooling fan control module.
Electronic Control Assembly
  • Located under the left side of the instrument panel.
Electronic Engine Control Power Relay
  • Located behind the glove box on the right side of the instrument panel.
Fuel Pump Relay
  • Located behind the glove box.
Horn Relay
  • Located in the fuse block.
Fig. 1: Main fuse box located on driver's side to the left of the steering wheel, above the brake pedal

e55ee77.jpg
This is the best info I could find....I hope this helps ya!

Jul 23, 2009 | Mercury Topaz Cars & Trucks

Not finding what you are looking for?
2001 Chevrolet Suburban Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...