Question about 2006 Chrysler Town & Country
How to get to it
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
It is your power steering pump. The solution is to replace the P/S fluid resevoir and fill or flush the system.
Posted on Mar 08, 2009
I've done this many times
You will need a tubing cutter
I think a 7 or 8mm socket
the appropriate amount of heater hose
cut the steel heater line at the front in a place you can get access to,leave yourself enough steel hose on the rear to allow you to put the heater hose on cut off the steel hose and discard, and use 2 hose clamps on either end do the same for the other heater hose,this way is cheap and easy and permanant.Be sure that when you run the heater hose keep it away from hot or moving parts,use the zip ties to fasten it along the way,this should take about a half hour or so depending on your skills and working conditions,remember to buy some antifreeze to top up the system because you are going to spill some,remember to clean any spills animals love it and it is deadly.
Posted on Apr 16, 2009
this lower tube is coolant inlet tube to water pump..dealer part as far as i know..they will know what one it is if you describe it..fairly common part..not too bad to replace
Posted on May 17, 2009
Jun 17, 2009- ok I just looked at it. it is simple.
the lens pivots and presses a switch in on one end to make the light come on. take a butter knife or very small screw driver and reach in between the lens and the black center console. there you will CAREFULLY press a flat tab to the side that is made onto the lens ( I hope you dont break this tab).
on the very opposite position on the clear lens towards the door is where the lens has a tab that has a small hole in it. there is a plastic pin made onto the console trim that fits into this hole so the lens will pivot. this will give you an idea of which direction to pull the lens when you press in the tab,. it does look like it would break easily. I havent had to take mine off yet thankfully.
please visit again and rank this answer if this helps!... good luck
Posted on Jun 17, 2009
Tips for a great answer:
Aug 22, 2016 | 2008 Chrysler Town & Country
Jul 17, 2014 | 2008 Chrysler Town & Country
Jun 28, 2014 | 2006 Chrysler Town & Country
Dec 09, 2013 | 2006 Chrysler Town & Country
Feb 01, 2013 | Cars & Trucks
Dec 31, 2012 | 2006 Chrysler Town & Country
May 18, 2011 | 1996 Chrysler Town & Country
Feb 01, 2011 | 2003 Chrysler Town & Country
Feb 17, 2010 | 2006 Chrysler Town & Country
27 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: