2004 oldsmobile alero ac diode blows out - 1999 Oldsmobile Alero

Harvey N Tawatao

• 3854 Answers
• Posted on Apr 13, 2009

SOURCE: ac trouble

TSB #01262004 -- THIS IS A PRODUCT SERVICE MESSAGE REGARDING THE NEW PART NUMBER FOR THE HEATER BLOWER RESISTOR FOR CUSTOMER CONCERN OF THE HEATER MOTOR NOT BLOWING ON ONE UP TO ALL SPEEDS. *TT (NHTSA ID #10012980, JANUARY 26 2004)

I hope this will help you, Was thinking of the blower resistor that control the different speeds and most of the time they were recalls. Just go back to the dealer and see if your covered.

If not i'ld take a close look at the switch and then the Resistor and if you need to know where it is, just ask the guy's at the dealer. Most of the time it's not to far from the blower motor.

Good luck and hope you can save time and money.

SOURCE: How do I remove the console around the shifter in

see the button just south of the gear shift? (and left of the e break) you need to push that down hard enough it will pop out. try using a small epice of wood or something and a hammer.

SOURCE: How do you remove the interior door panel of a 4

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.

SOURCE: how to remove the door panel of a 2004 alero

Check out this video it's a pretty good description of how to fix it.

http://pontiacremembered.com/blog/1aauto-com-fix-power-window-regulator-pontiac-grand-am-olds-alero-1999-06/

SOURCE: Replace serpentine belt on 2004

you should have a decal on the upper rad support or under the hood some were that shows the belt routing.there is a tool designed to move the belt tensioner but you may be able to use just regular hand tools to move the tensioner to take the tension off of the belt to replace it.the decal will show the tensioner location and you will have to figure out what tool is needed to move the tensioner.