Question about 1992 Dodge Ram 250

Open Question

1992 dodge converstion van 250 crank position sensor location

Trying to find a photo, since the autoparts store sold me the wrong book!

Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 39 Answers

SOURCE: 1997 Dodge caravan crank position sensor

it is located on the bellhousing of the transmission it gets its signal from the flywheel.look where the transmission bolts to the engine.

Posted on Sep 25, 2008

  • 4669 Answers

SOURCE: 2001 dodge 3500 van cam position sensor location

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

Posted on Jul 25, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Crank position sensor

This sensor should be on either side of the crankshaft pulley. It would be protruding across the surface of the crankshaft pulley. You can go to an autoparts site and look at photos of the part.

Jan 19, 2014 | 1993 Mercury Topaz

1 Answer

I have a 2005 dodge ram 5.7 hemi i have changed spark plugs, wires and crank shaft positioning cencer and the check engine light still comes on used a diagnostic and code po300 comes up random multiple...

I had the same problem and replaced the Crank sensor with one from the auto parts store, it lasted a month, then failed. Then I got a sensor from DODGE (dealer) and no more problems. The perameters for those sensors that come from the autoparts store are such that they fit a veriety of vehicles. The one you get from your local dealer is more specific to your vehicle. When this sensor malfunctions, it can created multiple trouble codes, but it's a single fix. Also check that your wires are routed correctly.

Aug 05, 2013 | 2005 Dodge Ram 1500

1 Answer

I have a 2001 dodge ram van 3500 wuth a 5.2 and i am trying locat the cank position sensor where can it be

it goes between the trans and engine on the passenger side take off the inside cover to see it

Jul 17, 2012 | 2001 Dodge Ram 3500 Truck

1 Answer

2001 dodge 3500 van cam position sensor location

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

Jul 25, 2010 | 2001 Dodge Ram 3500 Truck

1 Answer

I have a 1992 dodge dakota and awhile back i blew the engine. well we rebuilt it having it plained down and everything...then one day i was driving it and it just died and wont start. Its getting gas and...

when you say it has gas are you sure fuel is being injected by the injectors?
if not sure get whats called a noid light, sold at all large auto parts chain stores.they are inexspensive.plug it in to an injector connector and have someone crank engine if it blinks then injector signal ok. the light will give a dim blink which is ok.
no blink check for a blown fuse/loose connector/short to ground from engine to computer.
other causes of no start would be;
timing chain slipped
plugged exaust [melted down cat converter]
low fuel pressure
a major sensor failure,map sensor/throttle position sensor/crank,cam sensor
pcm [computer] failure or wireing to it
ignition switch
low compression

Mar 30, 2010 | 1992 Dodge Dakota

1 Answer

Replacing a crank sensor

I highly recommend you to buy the manual book of your van, thats the best thing you do. The book may cost $20.00 or more now.

Nov 04, 2009 | 2003 Dodge Caravan

1 Answer

1998 Dodge Dakota 5.2l V8 Stalling.

the sensors are located behind the catlet converter they sometimes look like a spark pulg if you cant find it pick up a book at any autoparts store and that will tell you where it is and how to change it

Apr 13, 2009 | 1998 Dodge Dakota

1 Answer

Trying to locate the fuel injector Pressure regulator for a 1992 dodge Gran Caravan with a 3.3 motor

I heard nothing back so I went and bought a book for 49.95 for that van Tkx all

Mar 06, 2009 | 1992 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides