Question about 2003 Porsche 911 Carrera

Open Question

Spoiler on my 911 turbo works but light on dash says failure

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 52 Answers

SOURCE: Replacing front spoiler on Porsche 911-996 - how do I do it..?

If you mean the small lower lip spoiler, remove the screws from the inside edge near wheel (1 small phillips screw each side) then tug spoiler fromone end to release plastic lugs that locate spoiler into front p.u.

Posted on Sep 06, 2009

Ad
  • 30 Answers

SOURCE: the rear spoiler on my 1995 911 porsche carrera will not retract

There is a control computer for the wing under the passenger side dash. Check to make sure the connector to this computer did not come loose.

Posted on Feb 04, 2010

  • 30 Answers

SOURCE: I have a 1991 911 Porsche. The ABS Light comes on

This is all related to the vehicle speed sensor. This sensor sends information to the speedometer, abs, and wing computer. You need to get it replaced and it should fix all the problems.

Posted on Feb 04, 2010

  • 52 Answers

SOURCE: how to remove the rear automatic boot spoiler of a

What you need to do is raise the spoiler via the switch to the full extent and place pieces of wood between the spoiler and body, then using a 'C' spanner to fit round the top of the rams and locate into the small hole (i found the multi purpose spanner that comes with pushbikes has just the right fitting) turn each ram 1/4 turn, but be careful because when it releases from the spoiler the ram will retract into its housing with great force taking the spanner with it and damaging the body. good luck!

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

964, rear spoiler won't work


Start by checking remote switch. Test to see if there is power at the spoiler motor. If there is power getting to the motor check for bad ground. Finally remove the cable that drives the spoiler up and down and apply 12v dc to the motor. If the motor turns check to see if you can turn the cable without the motor and that the spoiler moves. I all power checks out and the spoiler won't move by turning the cable, the gearing that the cable attaches to is most likely damaged.

Jan 19, 2014 | 1991 Porsche 911

2 Answers

I have a 2002 Porsche 911 C2. Where in the fuse panel is the fuse for the rear spoiler?


hello there
The fuse for rear spoiler is at the fuse section "D"
fuse number 8... 15 amp

proporsche

Jan 28, 2011 | Porsche 911 Cars & Trucks

1 Answer

Porsche 1996 993 c2: wing light stays on. It doesn't operate on its own but goes up and down in the manual mode.


Hello there
On passenger side under the dash is a relay for operating the rear spoiler.
The part number is 964 618 212 00.
This could be most likely your problem.
ivan
proporsche@yahoo.com

Oct 19, 2010 | 1995 Porsche 911

1 Answer

How to remove the rear automatic boot spoiler of a 2005 porsche 911 turbo?


What you need to do is raise the spoiler via the switch to the full extent and place pieces of wood between the spoiler and body, then using a 'C' spanner to fit round the top of the rams and locate into the small hole (i found the multi purpose spanner that comes with pushbikes has just the right fitting) turn each ram 1/4 turn, but be careful because when it releases from the spoiler the ram will retract into its housing with great force taking the spanner with it and damaging the body. good luck!

Feb 09, 2010 | 2005 Porsche 911

1 Answer

The rear spoiler on my 1995 911 porsche carrera will not retract. What fuse corresponds to the spoiler?what else could the problem be


There is a control computer for the wing under the passenger side dash. Check to make sure the connector to this computer did not come loose.

Jan 23, 2010 | 1995 Porsche 911

1 Answer

I have a 1991 911 Porsche. The ABS Light comes on


This is all related to the vehicle speed sensor. This sensor sends information to the speedometer, abs, and wing computer. You need to get it replaced and it should fix all the problems.

Dec 23, 2009 | 1991 Porsche 911

1 Answer

Replacing front spoiler on Porsche 911-996 - how do I do it..?


If you mean the small lower lip spoiler, remove the screws from the inside edge near wheel (1 small phillips screw each side) then tug spoiler fromone end to release plastic lugs that locate spoiler into front p.u.

Aug 08, 2009 | 2002 Porsche 911

3 Answers

2002 Beetle Turbo S Spoiler Malfunctioning


try lubricating the joints on the spoiler and lift mechanism. use a teflon based lube. or something similar so that it doesn't gum up the hinges


good luck
Jason

Jan 20, 2009 | 2002 Volkswagen Beetle Turbo S

1 Answer

Flat Turbo Transition


Go to pelicanparts.com go to the 911 tech area for great help.

Jim

Jul 05, 2008 | 1987 Porsche 911

Not finding what you are looking for?
2003 Porsche 911 Carrera Logo

Related Topics:

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

907 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...