Question about 1998 Ford Expedition

1 Answer

1998 ford expedition

- side of battery

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 424 Answers

If you mean size of battery,it is an 65 series 650 cca

Posted on Jan 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford expedition horn honks when replacing battery


Change the horn relay and look for bad grounds. May have bad switch in steering wheel.

Jan 27, 2013 | 1998 Ford Expedition

1 Answer

Cant find fuse for battery on 1998 ford expedition


there is a fuse under the hood on the fire wall underneith a black cover on the left side as your looking at it there is another cover to get to the fuse

Dec 03, 2011 | 1998 Ford Expedition

1 Answer

Where is the fuse box located at my Ford Expedition 1998?


there are two of them one under the driver side dash board up a bit on the far left. The other is under the hood near the battery. I believe its on the left front corner of the vehicle under the hood.

Dec 27, 2010 | 1998 Ford Expedition

1 Answer

I locate oxygen sensor on my ford expedition


for 1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl the Oxygen Sensor is located under vehicle, driver side, below seating area, mounted in exhaust pipe in rear of catalytic converter.

Application: Number three

Hope helps (remember rated this).

Aug 09, 2010 | 1998 Ford Expedition

2 Answers

1998 ford expedition will not start all lights and radio operable checked battery, alternator and starter all operable


their is a solenoid on the passenger side fender. replace it and the engine will crank and start. they are about 15.00 at any of your local auto parts stores. its called a starter relay.

Jul 19, 2010 | 1998 Ford Expedition

1 Answer

On a 1998 expedition, where is the pcm and the ecm--5.4 litre


1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl

PCM Ford's Location:
* Ranger - behind instrument panel (cowl), center to both driver and passenger sides.
* Explorer/Mountaineer - behind instrument panel (cowl), (access from engine compartment dash panel) on passenger side to center of vehicle.
* All other F-Series, Expedition/Navigator - lower dash panel on passenger side.
* Excursion - lower dash panel on driver side.

The PCM is behind the glove box and has a big harness connector in the firewall that you access from the engine compartment.

REMOVAL & INSTALLATION

a927c58.jpg

Fig. 1 The calibration number will be needed to order such parts as a replacement PCM, various sensors, and almost any emission control component. Typically this number is attached to a label found on the driver's door or the door pillar


1997-00 F-150, F-250, Expedition and Navigator

00a02b5.jpg

Fig. 2 Loosen the connector retaining bolt and remove the PCM connector

2cda058.jpg

Fig. 3 Remove the passenger side front door scuff plate

1fe310f.jpg

Fig. 4 Remove the passenger side kick panel

234c3f5.jpg

Fig. 5 Remove the PCM bracket clip and remove the PCM
  1. Remove the battery and the battery tray.
  2. Loosen the connector retaining bolt and remove the PCM connector.
  3. Remove the passenger side front door scuff plate.
  4. Remove the passenger side kick panel.
  5. Remove the PCM bracket clip.
  6. Remove the PCM.
To install:
  1. Installation is the reverse of removal.
  2. Tighten the PCM connector retaining bolt to 36-44 inch lbs. (4-5 Nm).

Hope helps.

Jul 13, 2010 | Ford Expedition Cars & Trucks

2 Answers

Fuel pump reset button location 1998 ford expedition


It is on the front passenger side, under the side panel. Hope this helps.. Cobra :-)
373118a.gif

Jun 12, 2010 | 1998 Ford Expedition

1 Answer

1998 Ford Expedition Fan Blower Resistor Location


It should be located on the blower motor housing under the right side of the dash, it will have wiring connector and 2 screws holding it in.

Jan 09, 2010 | 1998 Ford Expedition

1 Answer

1998 Ford Expedition won't start after changeing ignition.


Yes. You have to take the car to a ford dealer and have the new key programmed. This should solve your problem. Good luck.

Jun 29, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
1998 Ford Expedition Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...