Question about Cars & Trucks

Open Question

07 nissan ud 2600 turbo air pressure located

Ingine ligth is on

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: INTAKE AIR TEMPERATURE CIRCUIT HIG INPUT

It is in the air intake hose on the 4.3 and stuck in the airbox on the 2.2.

Posted on Jun 17, 2009

Ad
available269
  • 41 Answers

SOURCE: 1995 nissan santra

Take out one of your ignition wires.. Take out one of your spark plugs.. Use one of the compression tester they have at Auto Zone, O'rellys auto.. You most have more than 8 pound of pressure if you less somthing wrong with that particular piston.

Posted on Oct 13, 2009

c17hydro
  • 2984 Answers

SOURCE: i need to locate where the fuel pressure regulator is

Hope this helps!


8912a58.gif

Posted on May 11, 2010

mcdevito75
  • 1970 Answers

SOURCE: where is the 'idle air control valve located' for

mcdevito75 here, The Nisson dealer will have it"s location, or ant parts store may have a manual showing it"s location.

Posted on Jun 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a wiring diagram for UD Nissan truck 1985 Model CMA86K made by International Harvester Australia


check the manufacturer as Nissan UD trucks were imported fully assembled from the factory
the 5 ton truck is still a Nissan UD but is re-badged to International brand in the factory before shipping

Aug 30, 2017 | Nissan Cars & Trucks

1 Answer

My 1992 nissan terrano blows to much black smoke .how to fix this .some say i have unbirt fuel?


if diesel and turbo , check turbo operation of for holes in the intercooler
if turbo or naturally aspirated check/ replace injector tips as black smoke indicators squirting and not atomizing
if petrol check for excessive fuel pressure, faulty injectors , leaking injector seal
regardless of petrol or diesel --black smoke indicates incorrect air / fuel ratio ( too much fuel) so injectors, intercooler, bad turbo or blocked air cleaner are all candidates for the fault

Dec 04, 2016 | Nissan Terrano Cars & Trucks

1 Answer

How do i fix a brake buzzer that goes off while driving a nissan ud 80 truck,seems like the air pump cannot keep up


if it has a belt driven air compressor check belt and tension
it could be a buzzer problem
it could be an air leak in the system ( possible in the park brake diaphragms )
install an air gauge in the drain plug of a tank and monitor the air pressure use
with the truck being driven normally then the tank pressure should not show much variation
test the brake system by tuning the engine off, hold and apply the foot brake and see if the pressure continues to diminish indicating a leak in the system or foot valve operation
finally take it back to nissan ud as it will be still under warranty

Aug 24, 2016 | 2012 Nissan NV

1 Answer

The chek ingine ligth is on on my 2000 nissan maxima and the code is 1320 i whant to now what it is


What I found on the internet was that P1320 is a
transistor in the ignition coil, that turns on the primary
side of coil

Maybe a 1320 is similar to a Generic PO303
eg: coil #3 middle plug firewall side

You can put the P1320 into the computer & continue
on for the answer

Maybe a bad #3 cylinder coil, if the code actually
is accurate. On my Lincoln, even professional scan
tool software, isn't always of any use, sometimes,
because of coils not grounding properly & coming
back on the TPS Sensors

Sep 05, 2012 | Nissan Maxima Cars & Trucks

1 Answer

Where is the 'idle air control valve located' for a 1991 nissan 300z fairlady non turbo?


mcdevito75 here, The Nisson dealer will have it"s location, or ant parts store may have a manual showing it"s location.

Jun 17, 2010 | 1991 Nissan 300ZX

1 Answer

1995 nissan santra


Take out one of your ignition wires.. Take out one of your spark plugs.. Use one of the compression tester they have at Auto Zone, O'rellys auto.. You most have more than 8 pound of pressure if you less somthing wrong with that particular piston.

Oct 13, 2009 | Nissan Cars & Trucks

2 Answers

INTAKE AIR TEMPERATURE CIRCUIT HIG INPUT


It is in the air intake hose on the 4.3 and stuck in the airbox on the 2.2.

Jun 17, 2009 | 1998 GMC Sonoma

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...