Question about 2004 Ford Explorer
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: MY 98 FORD EXPLORER CRANKS
You mean that the starter is turning (cranks) the engine but the engine won't start? Be sure it is getting fuel. Turn the key to the on position and you should hear the fuel pump in the fuel tank run for a few seconds. If so that is good. If the fuel is being delivered then possibly you have no spark which usually is the electronic ignition module. The only way to test it is to replace it. Your timing chain or belt could be broken or "jumped" as the third possibility. I am leaning toward ignition module being bad as they just die without warning and nothing can revive them.
Posted on May 18, 2011
immobilsor has come on so only course of action is to call a specialist auto locksmith or the dealer to release the immobilisor ,have you lost the chip out of the key?? have a look and try the spare key
Posted on May 25, 2011
SOURCE: 1998 Ford Explorer, 4.0 SOHC No
You are at thhe right trail what controls spark is coil pack crank sensor sparkplugs and plug wire but the most important is power . I mean 12 volt connections and ground This includes checking fuses you need a simple volt meter doesnt have to expensive or fancy just to pick up 12 volts let start with fuses in the engine juction box (there not mark to what it belongs to) make sure none are open. especially fuse 19 and 24 , next go to the crank sensor make sure the tabs are snuggly on now to the coil pack there is a red and light green wire this comes from ignition and feeds 12 volts at the coil pack measure that voltage is it 12 volts if not correct it this is from ignition switch ( you can make a tool that feed 12 volt with a wire and a fuse in series and attatch it to battery and the primary wire this is known as hot wire) next go to the ECM wiggle the wires see if that get a connection going if not go back to the ICM here are the wire you are to measure the tan light green, this is from ECM and it is pulsed it measure 5vlts to 0 volts switched then measure the tan orange the same thing 5 volts to zero,then tan white again 5vlts to zero. any one of these 5 to zero fails you fix is the ecm
Posted on Aug 21, 2011
Tips for a great answer:
Feb 27, 2013 | 2004 Ford Explorer
Feb 20, 2013 | 2002 Ford Explorer
Feb 07, 2013 | 2004 Ford Explorer
Jan 29, 2013 | 2004 Ford Explorer
Sep 17, 2012 | 2004 Ford Explorer
Aug 20, 2012 | 2004 Ford Explorer
Jan 17, 2012 | 2004 Ford F250
Aug 23, 2011 | 1991 Ford Explorer
89 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: