Question about Cars & Trucks

Open Question

REPLACING 2005 CHEVY EQUINOX AWD DIFFERENTIAL BEARING

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 79 Answers

SOURCE: 2005 chevy equinox temp gauge showing hot fan

check the coolant temp sensor

Posted on Mar 22, 2009

handybc70
  • 25 Answers

SOURCE: where and how to change cabin filter chevy equinox

Hiya...the cabin air filter is located below the front passenger/windshield area.
It's only accessible by standing outside the Equinox with the hood open.
Here's how to do it...(before you pop open the hood)

1) Stand outside at the front-right door area.
2) Just below the front windshield area, pull up a few small black plastic clips that's on the black windshield wiper cowl area- a small flat screwdriver or a special clip-remover tool is handy.
3) Raise the hood up.
4) There may be a triangular-shaped hard foam sound damper at the left side nearby the hood hinge...pull it off if it allow you to work around it with ease.
5) Continue to find a few black plastic clips around the black windshield wiper cowl area.
6) Gently pull up the black windshield wiper cowl cover with care not to bend it too hard during removal.
7) You should see the cabin air filter inside that's held in place by a black rectangular box inside.
8) There's 2 black tabs that holds the cabin air filter in place.
9) Insert your finger or tool to pry the cabin air filter away from the tabs.
10) Remove old cabin air filter.

Remember to reinstall the clip parts back into place when you're finished.

Posted on Apr 05, 2009

  • 1 Answer

SOURCE: Rear Wheel Bearing Repair; 2005 pontiac aztek

Remove the brake caliper
Remove the disc, (rotor)
Remove the 34mm nut on the axel shaft
Remove the three (3) bolts from the back side
You will need a wheel puller (three jaw will work well)
Place the puller over the hub and tighten, this will push the shaft out of the hub. Now you have to pull the hub assy. out of the mounting bracket. I found hitting each side,of the hub with a lead hammer to work well. Don't forget to disconnect the ABS senser on the back side of the hub assy.
Do not over tighten the 34mm axel nut when you install the new assy. If you use an impact whrench on it you will damage the bearing.

Posted on May 03, 2009

  • 2 Answers

SOURCE: need to replace driveshaft carrier bearing, will not come off transmission end.

First mark the relationship of the two yokes and then remove the universal joint. Now that's done remove the retainer clip from the top of the slip yoke and gently tap the slip yoke out being careful not to damage the splines on the shaft. the bearing that ins on there is pressed in so (A) you can bring it to someone with a press or (B) use a gear/ pulley puller. If you attempt this take your time and have patience don't break anything and think safety first.

Posted on Jan 05, 2010

  • 2 Answers

SOURCE: 2005 chevy equinox rear hatch not locking

I've had the exact opposite issue with my 2005 Equinox.
My rear door is locked and will not unlock.

Posted on Mar 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could be the problem when I hear grinding in the front end mostly when turning, Abs light is on, AWD lock light periodically flashes, and advtrac will not turn on?


possible a loose front wheel bearing or a failed front wheel bearing
the abs light sensor is probably touching the rotor
tack it back to the shop that did the job as there is a problem in the assembly of the unit.

Apr 30, 2015 | 2005 Mercury Mountaineer AWD

1 Answer

How many rear wheel bearings are there on chevy equinox 2005


There are two rear Wheel hub on a chevy equinox. You also have a rear differential containing bearings.

Sep 13, 2014 | 2005 Chevrolet Equinox

1 Answer

How do i check allowable movement in rear drive shaft differential on a 2005 chevy equinox


There is no "cheking"to be done other than what you have done already.The movement,ANY movement,only means the universal joint is shot and needs replaced.I'm sure you've noticed a steady vibration.It's coming from bad U-joint.Replace it.

Jun 22, 2014 | 2005 Chevrolet Equinox

1 Answer

Can you remove the driver side cv axle from a 2005 Chevy asteo van AWD permenanlry


The CV axle stub (end with the axle nut on it) supports the wheel bearing, removing the axle then driving on it would cause the bearing to wear prematurely. I would not recommend this. The front differential is also sealed by the cv assembly, removing it would cause the diff fluid to leak out . CV shafts for this van run $50-80. I would replace if it is bad, instead.

May 04, 2014 | 2002 Chevrolet Astro

1 Answer

My 2005 Equinox AWD has developed a low pitch howel in the aera of theleft rear wheel .After removing rear wheels ,and rotating the hub by hand it feels rough,I suspect it could be a bad wheel bearing,I am...


You don't pry anything

You replace the Wheel Brg Hub

Look on Rock Auto or Napa to see what they look like

Unless you have some experience & a lot of quality tools
I doubt your going to do that job at home

Aug 12, 2011 | 2005 Chevrolet Equinox

1 Answer

2005 Equinox: 2005 chevy equinox vibration at low speeds...


A low speed vibration is likely caused by a tire. Check to see if any rims are bent. Have the tires checked and replaced as necessary. If the tires are worn unevenly have an alignment done. If this is an AWD model check the driveshaft and support bearing.

May 18, 2010 | 2005 Chevrolet Equinox

1 Answer

I have a 05 Chevy Equinox awd, I had the same problem with the abs. its a grinding feel and sound. kinda like the abs is kickin in. the abs traction control lights are on. I put it on the abs computer and...


Is the sensor tone ring in the bearing or on the side axle. If the ring is internal to the bearing have you replaced the bearing when you replaced the sensor (sold as one unit normally, aftermarket). If the tone ring is external, check it for cracks or loose fit on the axle. Also the wiring integrity of the sensor from the connector in the wheel wheel back to the EBCM (electronic brake control module) should be checked as well. hope this will help you

Jan 31, 2010 | 2005 Chevrolet Equinox

1 Answer

Can't find a carrier bearing for my 2005 chevy equinox?


look up a company called fleet pride they are a drive train specailist if they dont have it they should be able to tell you who will. why cant your local dealer get you one?

Jun 01, 2009 | 2005 Chevrolet Equinox

1 Answer

Serpentine belt broke


Get a 3/8s drive rachet put in

May 27, 2009 | 2005 Chevrolet Equinox

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...