Question about 1997 Geo Tracker 2 Door

Open Question

1997 geo tracker speedometer doesn't work

Replaced cable before,quite working again

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: four wheel drive will not work on 1995 geo tracker

You need to take the cover off your hub and clean and grease the lock ring. It is attached to the spring. It sounds as though your hub is rusted open.

Posted on Mar 09, 2009

Ad
  • 13 Answers

SOURCE: SPEEDOMETER CABLE NEEDS TO BE REPLACED

There is no cable on the 93 Prizms.  The problem is one of two things, either the "vehicle speed sensor" or the instrument cluster itself.   I also have a 93, and the speedometer started acting up a while ago. Sometimes it would register 0 then it would spike up to 70 and stay there at highway speeds then back to 0 upon slowing.  I replaced both items from the junk yard.  The speed sensor at an auto parts store will run about $160, and a new cluster will cost A LOT more at the dealer! I first replaced the speed sensor with no luck ($5.00 at the junkyard) the same thing happened 0 or 70.   I replaced the cluster today ($13.99 at the junkyard).  That was it! Problem solved.  The cluster is EASY to replace, remove the 2 screws from the trim piece and remove trim.  Next, remove the 4 screws that hold the cluster in place; 2 at the very top (don't remove the ones just above the cover glass) and two at the bottom.  Pull one side of the cluster out; there are 3 plugs; squeeze the center of the plugs to release the clip and wiggle them free.  Connect the replacement cluster, but before screwing it in, do a check to make sure all the panel lights work.  I had a few that were burned out, so I used the old cluster lights to replace them.   I would try replacing the cluster first.  Good luck!

Posted on Apr 11, 2009

  • 137 Answers

SOURCE: Geo tracker wont shift after clutch and clutch cable replaced

this is common.
it is caused because NO ON ever changes the cable at 100k miles.
it then wears a groove inside the cable and jams where you cant see.
(got my car dirt cheap cuz no one could figure this out)

the next thing to happen (toss coin) is the fire wall cracks or the clutch pedal spline strips.
full story here,
http://www.kick-fix.com/tranny/clutch/clutch-on-kick.html

now you know the why , so now correct all the damaged caused by a $45 cable.

all parts are at suzuki , every single one.

Posted on Oct 22, 2009

  • 1757 Answers

SOURCE: looking for timing belt diagram on 97 Geo Tracker

Click on the following free, direct Link. It has the Timing Belt Diagrams, including Marks and Instructional Diagrams.

Let me know if this helped...

http://www.2carpros.com/car_repair_information/year/1997/make/geo/model/tracker/1997_geo_tracker_timing_belt_diagram_marks.htm

Posted on Apr 08, 2010

  • 72 Answers

SOURCE: 1995 4x4 geo tracker front wheel bearings

first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.

Posted on May 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 geo tracker 4x4 needs speedometer cable replaces


read the part about AIR BAGS first....
the FSM is 100% free, (factory service manual)
the cable just disconnects at the trans, easy.
its the speedo side that tricky
96 has the side impact braces there, making tad more tricky.
the book is here
http://www.acksfaq.com/trackerfsm.htm

chapter 8c , page 6

http://www.acksfaq.com/trackerfsm.htm

DIY: page.
http://www.fixkick.com/power-elect/cluster-pull/cluster-out.html

Sep 06, 2015 | 1996 Geo Tracker 2 Door

1 Answer

Speedometer and odometer don't work


I don't know what type of vehicle you have but usually when both the odometer and speedometer don't work, you need a new speedometer cable. My husband replaced the one on his 97 Tracker and it worked for 2 weeks and quit again. He just drives with the flow of traffic and in order to pass inspection he has to get a DMV Waiver every single year. He will never be able to sell it because he has no idea what the actual mileage on it is. He just drives it in bad weather and stuff since it has 4WD. I don't think the speedometer cable is very expensive. Good luck.

Oct 02, 2014 | Cars & Trucks

1 Answer

Need to replace my throttle cable on my 1997 geo tracker, where can i find one


Any auto parts store, like NAPA can order you one. Or you can get it thru the dealership.

Sep 25, 2014 | Cars & Trucks

1 Answer

Speedometer doesnt work


old post
it dont work like 1999 car. and newer.
its cable drive
is odometer working,
yes, then speed is bad. as most are.now..this old..
some make noise
others that and jerks.

Mar 31, 2014 | 1996 Geo Tracker 2 Door

1 Answer

Speedometer doesnt work


worn out pionn in speed sensor.replace speed sensor.

Feb 26, 2013 | 1995 Geo Tracker

1 Answer

Speedometer doesn't work


sounds like a faulty speed sensor check you electrical connections at the sensors as well as the transmission is the check engine lite on

Sep 04, 2012 | 1997 Volkswagen Cabrio

1 Answer

Speedometer not working


Check the flexible-cable that runs from the transmission to the the back of the speedometer.

Oct 29, 2009 | 1996 Geo Tracker 2 Door

1 Answer

How to Replace the crankshaft seal on a 1997 geo tracker


remove belts, pull out crankshaft pilley and then pull put seal

Sep 21, 2009 | 1997 Geo Tracker 2 Door

Not finding what you are looking for?
1997 Geo Tracker 2 Door Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...