Question about 1996 Dodge Dakota
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
you can try changing the ignition coil, I own a 97 Dodge 1500 and mine did the same and thats what i had to do.
Posted on Oct 08, 2008
i had this problem to, do not hook the ground wire from truck to your radio. use the braided wire that hooked to your old factory radio by inserting a bolt into the braided wire and ground from your new radio.
then check fuses one more time and you are good to go.I didnt think this would work but it did..
Posted on Dec 27, 2008
First of all let's explain how the spark gets to the plugs. There is a crankshaft position sensor and a cam sensor. They are what determines when to fire the coils and injectors. The crank sensor is located on the passenger side on top of the bellhousing, the cam sensor is the pickup plate in the distributor. As the engin turns the send refernece pulses to the computer which grounds and ungrounds the ignition coil causing it to discharge and send voltager from the secondary coil wire to the center tower in the distributor cap. The rotor button recieves the voltage and distributes it to the 6 towers (1 for each cylinder) If you say you're getting spark from the rotor that tells me the primary side of the ignition system is working, and the secondary side is working into the distributor cap. I'd check for spark out of the plug wires at the plugs. Pull a wire and insert a #2 phillips screwdriver into it, hol the shaft of the screwdriver aprox 1/8"(no more) from the exaust manifold and observe the spark as someone turns over the engine. You should see a nice blue spark. If theres spark, spray a little gum cutter in the throttle body an crank it, if it fires you have a fuel problem. Install a fuel pressure gauge on the schrader valve on the fuel rail and observe it as you crank it. If theres no fuel pressure maks sure there's fuel in the tank, if so climb underneath and beat on the bottom of the tank with a rubber hammer, the pump may be going bad, sometimes you can jar them and make them run.
Posted on Aug 24, 2009
didyou check the cranck sensor? or the distibutor pick up coil, those sensors pick the ignition signal for the computer and send the spark of the coil if any of those sensors are broken dont work the engine and plus check the injection pulses of the fuel injectors too . i hope be help for you fellow
Posted on Oct 20, 2009
Tips for a great answer:
May 16, 2015 | 1988 Dodge Dakota
Mar 09, 2014 | 1996 Dodge Dakota
Dec 09, 2013 | 1992 Dodge Dakota
Jun 06, 2011 | 2001 Dodge Dakota
Oct 16, 2010 | 1988 Dodge Dakota
Jun 06, 2010 | 1988 Dodge Dakota
Apr 25, 2010 | 1988 Dodge Dakota
Apr 22, 2010 | 1996 Dodge Dakota
Oct 20, 2009 | 1993 Dodge Dakota
44 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: