My car was broken into they rip down the glove box and removed a module. Its on the right hand side of the behind the glove box. Trying to identify the module. It had two connections one is 32 pin the other six pin.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The TCM is part of the ECM (electronic control module) and is not a separate module. The ECM is located behind and to the right of the glove box, you will need to remove the glove box liner to gain access to it. It has a large 60 wire connector going to it.
The ECM is located right behind the glove box. First remove the negative (-) battery cable. Then remove the front of your glove box, just a few small screws. The interior of the glove box is cardboard and will pull out after removal of screws. Then unplug the 3 electrical plugs and let them hang out of the way. Now, remove the bolts on the side of the bracket holding the ECM IN.
If you have the automatic controls you'll need to replace the blower power module behind the glove box.
1) Disconnect and isolate the battery negative cable. (2) Open the glove box. (3) Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening then roll the glove box downward. (4) Reach through the glove box opening to access and disconnect the instrument panel wire harness connector for the power module from the module con-nector receptacle. (5) Reach through the glove box opening to access and disconnect the blower motor pigtail wire connec-tor from the power module connector receptacle. (6) Remove the two screws that secure the power module to the evaporator housing. (7) Remove the power module from the evaporator housing.
I have a 1987 Dodge pick up and I had to reset my maintenance light. There is a EMR module located behind and to the right of the glove box. Just pull in on each rear side of the glove compartment box and it will drop down. There is an EMR module located to the right of the glove box behind the dash. Use a small rod or screwdriver and insert it in the small hole of the module and reset the switch.