Hello, ok, know that we have that problem..down, we removed that and know we have something else..in the way, a computer is on a bracket on 2 screws by the fan, how do we remove that, does it slide off, or how and what do we do to remove that""
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The only way to disarm these alarms is with the factory remote or turning on the ignition. To turn off the factory alarm.
Ok, do you have the remotes? If so, let's ID the system. Go to www.KEYLESSRIDE.com & use th fcc #s on the back of it.
If not try this:
Programming Factory Security on GM Cars and Trucks Instructions for programming the GM factory security systems that do NOT disarm from the driver's door key cylinder. This programming is for the cars and trucks listed below.
Step #2 Remove the radio fuse only (not the fuse that says acc/radio).
Step #3 Turn the key to the accessory position. When you do this you will get two chirps from the door buzzer. Should you hear only one chirp, your vehicle does not have factory security and these instructions do not apply. You need to hear two chirps.
Step #4 Press the unlock switch on the door. This will give 1-4 chirps depending on the program step. Continue pressing the unlock switch until you get to the desired chirp setting. 1 Chirp - Security off 2 Chirps - Remote Only 3 Chirps - Factory Setting 4 Chirps - Passive Arming
Hello: The auto down part of the system is in the switch if the window goes up and down when you hold the switch there is no need to remove the door panel. To replace the switch you just need to remove the switch plate, take a 6 in straight screw driver put something under it to protect the panel, push in and slightly down to release the clip and pry up.
Hello mikey_anaya: My name is Roger and I will try to help. If your Friend took out a spark plug and put a foreign object inside the cylinder? That person did you no favors. When the piston came up to top dead center. The object could not be compressed and would have locked up the engine. This would not only damage the piston but also damage the cylinder head. You will need a mechanic who can remove the object and check for damage. You might passably find a mechanic who has a bore scope. This will allow him or her to look at the object inside the motor. They might be able to remove the object from the cylinder if they can reach it with a magnet. If this can not be done the engine will need to be torn down and checked for damage. Like I said it will not be cheap. Sorry I could not give you a simple solution. Should you need further help please just ask. Please rate the answer you received. This way I know it was useful. Thank You for using Fix Ya. Roger
Hello you can remove the possitive battery cable and hook one end of a test light to the cable end then the other end to the battery. If the light comes on then there is somthing drawing voltage and make sure everything is off when doing this test .Now to narrow down where it is drawing from . Start removing fusses from the fuse box one at a time and puting back in watching the test light when the light goes off you know where the problem is .