Question about Cars & Trucks

1 Answer

Rear brake adjustment

No more adjustment at handle

Posted by on

Ad

1 Answer

Mystery Vehicle with rusted parking
brake cables.?

Get under the car & adjust the cable-- so you have
only 4 clicks in the car or you will fail inspection

Posted on Dec 01, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

95 Corsica emergency brake not working, pulls all the way back not locking


ray365m hows the rear brake shoes if you have rear drums if there good try adjusting the cables at the bottom of the (e) brake handle pull the boot back theres a 10mm nut to adjust

Jun 28, 2014 | Cars & Trucks

1 Answer

When i pull the ebrake and then release it its staying on i have replaced the handle and the main cable from the front to the rear and its still sticking what do i do???? Thanks Travis


adjustment is out, start at rear brakes inspect cable action with wheel off and observe action when handle is engaged. it might have a broken spring there, the handle also has a spring., release brake and use screw driver to push back brakes ,take slack out of line at adjuster and that should be your adjustment. if it gets stuck again its at the brake caliper, wheel cylinder or hardware depending on make and year of car.

Apr 01, 2011 | Chevrolet Cavalier Cars & Trucks

3 Answers

Can i adjust e brake @ handle, or do i need to pull rotors and off to do it?


They should be self adjusting. Why are you trying to adjust them...too tight ? Too loose ?...you may just need new pads as the e-brake uses diff brakes than the hydraulic system brakes. Hope this helps !

Mar 09, 2011 | 2006 Chevrolet Trailblazer

1 Answer

I adjusted handbrake shoes but lever is still very long


First make sure that both cables are good, jack rear wheel and apply emergency brake then see if both wheels lock up, this test is to make sure both cables are working, if there good then adjust the e brake handle at the handle, theres an adjusting nut at the rear of handle this is done from inside the car,

Aug 28, 2010 | BMW 530 Cars & Trucks

1 Answer

How to adjust the parking brake


If this vehicle has rear drum brakes then make sure the rear shoes are adjusted properly.If this vehicle has rear disc brakes then check for adjustment screw at park brake handle and adjust as required. MOE

Jun 22, 2010 | 2006 Toyota 4Runner

1 Answer

How to adjust the emergency brakes?


Slacken off the cable at the e brake handle , check the cable underneath for any adjusters if there are slacken them off also , Next look for little rubber plugs in the backing plates of the rear brakes remove and using a screwdriver or brake adjusting tool wind the adjusters until the wheel is rubbing on the brake shoes get the 2 rear brakes rubbing the same the adjust the e brake at the handle until it clicks 3 or 4 times when you pull it up and that should be about right.
Hope this helps

Jul 08, 2009 | 1993 Toyota Corolla

1 Answer

2005 Outlander has now new rear brake shoes and


Under the center console is a Y in the cable that leads under and around the top/rear side of the brake handle. At the top/rear of the handle is a locknut and threaded shaft to adjust tension.

Be sure to not have any drag on the brakes when you are done adjusting!

Jun 12, 2009 | 2003 Mitsubishi Outlander

2 Answers

How to adjust emergency brakes


you can use 10mm socket to adjust cable while hand brake is off. it lives in hand brake handle area at rear of handle look with torch

Jun 03, 2009 | 1992 Toyota Camry V6

1 Answer

Emergency brake on a 2002 Caravan


There should be a cable running underneath the car along the rear axle from one wheel to the other that connects to the cable running to the front emergency brake handle.

Follow the cable until you find the adjustment screws and turnbuckle on the cable.

Loosen the screws holding the turnbuckle tight.
Adjust the turnbuckle until the cable is tight.
Test the brake handle and readjust if necessary.

Some cars have auto adjusting rear brakes which will sometimes re-seat by running in reverse and pushing on the brake several times. Try this first!

If none of the above works, you will have to take off the rear wheels and adjust the brakes manual at the wheel hub.

jackiaria

Feb 28, 2009 | 2002 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...