Question about 1999 Chevrolet Blazer

1 Answer

My 99 Chevy s10 blazer is turning over but won't start.. Sometimes all power seems to leave and the dash lights will only flash when I try and start it..starter is fine, battery is brand new, and

It's been doing this for a few weeks but in different manners.. Sometimes there is no power at all, sometimes just a jump will start it, but this time it turns over and seems like its going to start but then it just won't.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

It can be your mounting house for your spark plugs how to change it ?how to cheak it ? Well there should be 2 or 3 bolts holding it take the bolts out turn on your truck and remove it like you would if it was a cap in the inside should spin if doesent then thats another problem it wouldn't be your mounting house that will be a snapped little belt in the inside of motor not really sure what's it called. So back to your mounting house disconnect all ur spark plugs only connected to the mounting house ( remember we're they go) then remove the bolts and put the new one

Posted on Dec 25, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

66 chrgr
  • 1011 Answers

SOURCE: 1992 Chevy Blazer Tahoe Starter Removal 4.3l 4WD Vortec

you have to remove the cover over the torque converter 4 bolts holds this on .you may be able to just move it out of the way. and yes it does sound like a starter problem.i hope this helps

Posted on Feb 22, 2009

  • 1118 Answers

SOURCE: chevy tahoe won't turnover, power

Next time it won't start turn headlights on and see if they dim when you turn key to start, if they dim its most likely starter, if they don't dim possible starter switch, Have you tried to start it in neutral position? Try that, if it starts in neutral than its park neutral switch, if not could be starter switch, Just make sure you chk. all fuses and any relays associated with ignition first.

Posted on Feb 15, 2009

bunnydawg
  • 5158 Answers

SOURCE: My daughtrs 2001 Chevy s10 has an itermitant starting problem.

quick way to tell... next time it won't crank and just clicks... hit it gently with a hammer as you have someone attempt to start it... if all of a sudden it cranks.... it's the starter... replace it before it quites completely.

Robert

Posted on Dec 18, 2008

  • 22 Answers

SOURCE: 99 Chevy S10 Pickup's Tail Lights Won't Turn Off

Obviously you have a short somehow power is bleading over to this circuit. You may be forced to do some hard debuging (i.e wiring diagram, test light isolate the problem on the circuit).

If I were taking a guess I would try the following:
1) Remove the fuse for the taillight
2) If the light goes out I would start looking at the dashboard light switch
3) If the light does not go out then I would start looking toward the rear end of the truck wires that are scouffed, trailer light connections ect.

Hope this gives you a start, needless to say a short can take forever to find.

Posted on Feb 17, 2010

  • 218 Answers

SOURCE: 1997 chevy s10 blazerdash wont light up when key

the dash sound's like a fuse, check the fuse box under the hood and in the door jamb on the side of the dash, also check your fuel filter and fuel pump, im betting on the pump because i have a 2001 chevy blazer that has had two replaced and it has 233000km on it!

Posted on Jun 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 Chevy S10 Blazer that seems to start in second gear


run fault codes to check for servo/ solenoid problems --TCM faults

Jan 28, 2014 | Cars & Trucks

1 Answer

1999 Chevy Blazer S10.. Won't start.. It was


sound you have a blown clutch slave cylinder

Dec 05, 2012 | Cars & Trucks

1 Answer

I have a 99 chevy blazer won't start but will turn


You may have a fuel pressure problem or the secuirty system has locked you out for some reason due to a false signal or failed part. Do you have any electronic engine control codes? Is the Security light on in the instrument cluster and fishing when you try to start the truck? To check the fuel issue get a can of spray starting fluid from the auto parts store or any hardware store and spray it into the air intake of the engine while someone cranks the engine, if it starts you may have a defective fuel pump, the pump is located inside the fuel tank, the fuel tank must be removed to access and replace the pump.

Feb 14, 2012 | 2000 Chevrolet Blazer

1 Answer

2000 Chevy Blazer won't start after horn and lights flashing out of control


sounds like a faulty alarm immoblizer ,,,, .. if its a after fit system , disconect it and shoot it !!!

Feb 13, 2012 | 2000 Chevrolet Blazer

1 Answer

99 chevy blazer blows heat only sometimes


You need to check for a loose ground again. The dash seems to have a loose ground. Your heat and ac are controlled by motors that get input from your switch. You might try following that harness and see if there is a loose ground. Other than that I don't have a clue. You might also check near the firewall and make sure the ground strap there was bolted to the engine.

Dec 14, 2011 | 1999 Chevrolet Blazer

1 Answer

1999 CHEVY LUNINA WON'T START BATTERY AND


Check the dash once you turn the key to the run position the passlock runs a security check using a set resistance value through the chip in the key. If the security light begins to flash the reading it received was incorrect or it didn't get a reading at all. You can try reseting the value it is looking for by turning the key to start then releasing it. After 10 minutes turn it off then cycle it start again leaving it in on for 10 minutes then back to off then one more time. After the third cycle has completed for a total of 30 minutes. You should be able to turn the key on and start the vehicle. If the light continues to flash their is a problem with the chip in the key or the connections within the ignition its self. Both are common but a Pass Lock Relearn as described above will usually adapt to the poor connection values. Hope this helps.

Aug 28, 2011 | 1999 Chevrolet Lumina

1 Answer

1997 chevy s10 blazerdash wont light up when key


the dash sound's like a fuse, check the fuse box under the hood and in the door jamb on the side of the dash, also check your fuel filter and fuel pump, im betting on the pump because i have a 2001 chevy blazer that has had two replaced and it has 233000km on it!

Jun 04, 2010 | 1997 Chevrolet Blazer

3 Answers

2001 chevy blazer turns over but wont run. new fuel pump,new fuel filter,door switch ok,have gas and pressure at manifold, have spark,runs for a second with the help of starting fluid


Try to do the crank relearn:
Ensure that your battery is fully charged before attempting the relearn procedure. Do not leave any battery charger or jumper cables attached to the battery. Close the hood completely. Some applications require that the doors remain closed during the procedure.
96-99 S10
1. Rotate the key to the start position to attempt to start the vehicle (the vehicle will not start).
Allow the key to return to the all position (same as if the vehicle would have started). The theft system light will flash (or stay lit) on the dash for approximately 10 minutes.
2. When the theft system telltale stops flashing (or turns oft) turn the key to the off position for 5 seconds and then attempt tostart the vehicle. The vehicle should start on this cycle.
3. Once the vehicle is running, the password relearn is complete.

00 + S10
1. Rotate the key to the start position to attempt to start the vehicle (the vehicle will not start). Allow the key to return to the on position. (same as if the vehicle would have started)
2. The theft system light will flash (or stay lit) on the dash for approximately 10 minutes.
3. When the theft system telltale stops flashing (or turns off) turn the key to the off position for 5 seconds and then attempt to start the vehicle.
4. Repeat steps 1 through 3 two more times for a total of 3 cycles/30 minutes.
5. On the next cycle of turning the ignition key from off to crank the vehicle should start
6. Once the vehicle is running, the password is learned and this completes the cycle.
7. Clear any DTC's with a scan tool if necessary. DTC history will be cleared after 100 ignition cycles.

Thank you for using fixya and keep me posted, be glad to help you get your jimmy running 100%

Apr 26, 2010 | 2001 Chevrolet Blazer

2 Answers

Chevy blazer wont start 2002


if it turns over there are a cocuple of things to check. crankshaft sensor and the coil pack maybe the computer.id start with the crankshaft sensor

Jun 29, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Blazer Logo

249 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...