Question about 2004 Ford Expedition

Open Question

How to remove interior door panel on 2005 ford expedition

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 51 Answers

SOURCE: 2003 ford expedition "door ajar" & interior lights staying on

the wire on the door latch make sure they are plugged in or unplug it and the light should go out if it does not then it's not that door

Posted on Feb 16, 2009

Ad
lilward5
  • 5 Answers

SOURCE: how to remove front driver side door panel (2000 ford expedition)

There is a triangular piece, at top corner, covering a screw behind the mirror. Remove that screw. Remove the piece that covers the handle and remove the screw holding the handle to the door. Look through, where door handle was and remove another screw just above where the handle was. This screw is holding the panel to the actual door. Pop the cover off for the automatic door locks and disconnect them. Lift the panel in an upward direction.

Posted on Nov 14, 2009

  • 3 Answers

SOURCE: Remove door panel on a Ford Van

For a 1999 Ford Econoline 150 (assume the same or very similar), remove triangular plastic cover over mirror assembly by prying straight out, remove plastic door handle cover by prying up from the front side, remove electronic door switches by prying up from back side, remove round plastic cover at bottom rear of door panel. Four screws are now revealed, remove them. Lift door panel straight up, clips are hooks (not snap in). Work door switch assembly out of door panel. Set door panel aside. Reassemble in reverse order.

Posted on Nov 21, 2009

  • 1 Answer

SOURCE: how to remove interior door panel on 2004 ford

First pop off the door open handle back plate with a screwdriver. It just snaps on. Do the same with the switch cluster plate below which also snaps in place and remove the switch harness connectors. Next pop off the small narrow cover plate under the armrest pull handle to expose 2 Torx screws. Remove these screws. Next locate a Phillips screw in a retaining cup which is located on the end of the interior door panel just above the latching mechanism and remove that. Locate two 3/8" hex head screws at the bottom of the door panel and remove those. Grab the door panel by the armrest handle and pull up to unhook it from the door. If its the driverside door, you will also have to diconnect the mirror adjustment switch connector to free the door panel.

Posted on Mar 13, 2010

  • 286 Answers

SOURCE: how do remove a ford focus 2005 door panel

It's usually the window winder that presents the problem . Remove all visable retaining screws ie; Grab handle , Internal door opening lever , Button on top of panel (if applicable ) etc . The majority panel are a pop snap on type . Remove the winder lever withthe aid of a shoe lace or thin piece of cloth material, The winder is retained by a horse-shoe shaped spring clip. .... Pull the shoe-lace/ material in the opposite direction of the winder retainer clip and it will easily come off, but it is a spring clip and may fly off so be careful. Good luck

Posted on Apr 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove door panel


Expedition Trim Panel Removal

NOTE The door glass must be completely raised.
  1. Remove the window control switch plate.
  2. Remove the door handle bezel.
    WARNING To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
  3. Remove the two bolts and three screws, and remove the door trim panel.
  4. Remove the finish cover to access the two center screws.
  5. Disconnect the electrical connectors.

    zjlimited_454.jpg

    Fig. Expedition - Trim Panel Screws shown

  6. Remove the door handle bezel.
  7. Use service notch.
    WARNING To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips.
  8. Remove the two bolts and three screws, and remove the door trim panel.
  9. Disconnect the electrical connectors.

    zjlimited_455.jpg

    Fig. Navigator - Trim Panel Screws shown

  10. Position the water shield aside.
  11. If equipped, disconnect the lock cylinder rod.
  12. Disconnect the exterior door handle actuating rod.
  13. Remove the bolts and position the front door latch aside.
  14. Disconnect the electrical connectors.
  15. Release the interior door handle cable and remove the front door latch.
  16. Position the cable cover aside.
  17. Release the conduit and the interior door handle cable.
  18. Release the locking tab and remove the front door lock actuator.
  19. To install, reverse the removal procedure and note the following:
    1. Tighten the door latch screws to 80 inch. lbs. (9 Nm).

This procedure is followed to check and fix door locks.

Hope helps.

Jan 12, 2011 | 2001 Ford Expedition

1 Answer

How to remove interior door panel on 2004 ford expedition?


First pop off the door open handle back plate with a screwdriver. It just snaps on. Do the same with the switch cluster plate below which also snaps in place and remove the switch harness connectors. Next pop off the small narrow cover plate under the armrest pull handle to expose 2 Torx screws. Remove these screws. Next locate a Phillips screw in a retaining cup which is located on the end of the interior door panel just above the latching mechanism and remove that. Locate two 3/8" hex head screws at the bottom of the door panel and remove those. Grab the door panel by the armrest handle and pull up to unhook it from the door. If its the driverside door, you will also have to diconnect the mirror adjustment switch connector to free the door panel.

Mar 11, 2010 | 2004 Ford Expedition

1 Answer

How do I remove the driver's door panel on a 2005 Ford Expedition? I need to replace the driver's door mirror.


omg wow i busted mine all apart on mine dont do it keep calm i got to mad but when you remove the switches windows lock etc theres a screw in there when you get all screws removed work from top bottom doest come out stragight pry all clips from top to about 3/4 down panel when all loose pull up on panel while pulling out

Feb 14, 2010 | 2005 Ford Expedition

1 Answer

How do you remove the interior door panel on a 2002 expedition?


Remove all the screws that you can see, when the panel is loose, lift it straight up about an inch and it should come right off.

Feb 10, 2010 | 2002 Ford Expedition

1 Answer

How to remove a interior door panel for a 2001 ford expedition


Pop the small triangle panel off at the front of the door, by the side mirror and remove the screw. Then remove the red and white lens at the bottom of the door and remove that screw. Lastly pop off the plastic insert by the inside door handle and remove the door hande using a rachet and extension, dont remember the size of bolt. Once that is off the door panel should lift straigt up after that. There are none of the plastic tabs that are secured to the door panel that get inserted to the door frame like other cars.

Jun 08, 2009 | 2001 Ford Expedition

3 Answers

2003 ford expedition "door ajar" & interior lights staying on


the wire on the door latch make sure they are plugged in or unplug it and the light should go out if it does not then it's not that door

Feb 15, 2009 | 2003 Ford Expedition

2 Answers

I need to replace passenger side mirror on 97 ford expedition


Both above answers are not right... I just replaced the Pass side power mirror assembly on my 97 Expedition. No heat, no directional.
The inside door panel must come off.
1. pry off interior triangular plastic trim piece inside of door at mirror area. Remove door panel screw at this area.
2. Pry off power window switch panel and remove door panel screw at this area.
3.Remove interior door light cover and remove screw at this area.
4. Remove plastic cover at door handle.
5. The interior door panel can now be lifted up to release it from it's fasteners.
6. Disconnect light and push power window switch assembly through the door panel and it can be set aside.
7. Disconnect mirror power at coupler.
8 Loosen three mirror mounting screws with 7/16 socket. DO NOT unscrew completely.. the will fall down the door cavity. Use a round magnet on holder to remove the screws completely.
9.Thread electrical connection into door panel and install mirror.
10. Smile when mirror works and drink a beer!
rayman

Dec 27, 2008 | 1997 Ford Expedition

1 Answer

2005 Ford Expedition XLT, major electrical problems


You have a wiring harness problem
Take it to the dealer directly.......

Nov 18, 2008 | 2005 Ford Expedition

Not finding what you are looking for?
2004 Ford Expedition Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...