Question about 1988 Ford Crown Victoria

1 Answer

1988 Crown Victoria 5.0 Taillights, license plate light, trunk light stopped working

First the license plate light stopped working, then the taillights. A similar problem occurred in my '87 Crown Vic Police interceptor. Is there an electronics module that I can replace?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Expert
  • 129 Answers

Check fuss first under carpet in trunk there is module

Posted on Nov 30, 2012

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 66 Answers

SOURCE: 99 crown vic police interceptor steering wheel??

i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!

Posted on Jul 07, 2009

  • 103 Answers

SOURCE: Speedometer and odometer does not work in 1998

Either the speed sensor,or the dash cluster is of fault. Have Auto Zone test the speed sensor,if ok ,,, I would replace the cluster ( buy used ) much cheaper.
Please rate this.

Posted on Jul 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 ford crown victoria electrical issues


Light switch or bad earth problem unless the fuse is getting dirty fuse holder.

Apr 24, 2014 | 2004 Ford Crown Victoria

1 Answer

2004 ford crown victoria taillights go off


Is that when the light switch is turned on or when the brakes are applied? Please specify the condition and I will have a better idea of the problem?

Apr 24, 2014 | 2004 Ford Crown Victoria

1 Answer

No ac no heat no power to the to or maybe from the dash control panel


There are 6 bolts that hold the rear trunk panel on the trunk itself: 4 behind the license plate on the outside of the trunk and two inside the trunk panel trim.
1. Remove the license place from the DeVille rear trunk panel.
2. Remove the 4 bolts located below the license plate.
3. Remove the trunk panel (felt) trim inside the trunk.
4. There is a small bolt on each side of inside trunk panel (4mm I believe). Remove them. Each will have a rubber washer on them so you'll know you are removing the correct bolt.
5. From the outside of the trunk, lift out the rear trunk panel. The license plate light (and reverse lights) are removed by turning the light assemblies counter clockwise.

Aug 27, 2013 | 1997 Cadillac DeVille

1 Answer

Can't find the fuse location for the license plate lights.


License plate light runs on your light system..if all other lights work....outside of car...u have either a bad bulb or bad wire ib Lic plate area

Aug 28, 2009 | 1998 Ford Crown Victoria

1 Answer

Taillights and license plate lights not working


there is a short somewhere.put a test light in place of the fuse.
the light will glow bright.when the short is removed,the light will go dim

Jul 18, 2009 | 1997 Nissan Pathfinder

1 Answer

Troubles removing license plate light bulb


yes,thats the only way sorry to say.

Mar 02, 2009 | 2002 Buick Regal

2 Answers

1992 crown vic blinkers stopped working


It can be wiring connections, try to check the wiring coming to the blinkers.

Dec 02, 2008 | 1992 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...