Question about 1995 Volkswagen Jetta

1 Answer

Wippers does not go down to original possition when switch off

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 537 Answers

Wiring or motor problem. Check motor for dirt at the connection inside the conector cover where you have contacts that stop the motor at the right position.

Posted on Nov 30, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a cutlass 1985 supreme an i put another sternwheel from another cutlass 1985 my cutlass 1985 supreme did not have a tilt sternwheel so now i put one in there an when i turn the switch on it do mot...

You are going to have to test all the wiring to see if you have a short somewhere. Personally i would check the wiring before replacement of any parts

Dec 28, 2014 | 1985 Oldsmobile Cutlass Supreme

3 Answers

I replaced the wipper morter and the wipper switch and checked the fuse but the wippers still go on after ten minnets when you put them on they dont work wright away

I don't know the specifics of your vehicle, so this is a general comment. I suspect the problem is in the intermittent wiper electronics, which I assume your vehicle has. I'm guessing there is a wiper control module somewhere under the dash.

Jun 28, 2014 | 2000 Jeep Grand Cherokee

1 Answer

Wiper relay

If u opend the cover where fuses are u will see its written wippers or take each relay and try to turn the wippers if it didnt that is mean its that one then switch it with other one and check

Feb 28, 2014 | 1997 Buick LeSabre

1 Answer

How do u fix windshild wippers?

Sure! I have a 1998 malibu, and the windshield wippers are not moving when I hit the switch; But I can hear the motor. I think its just off track are something, but I dont know.

Apr 24, 2011 | 1998 Chevrolet Malibu

1 Answer

My wipper on the back dont work

Have to trace the line down to the switch. Check the fuse in the inside box marked rear wiper.
If there is power in fuse and switch contacts then it must reach the motor in the hatch door. check the voltage to it , if present check motor or the parking switch inside the unit,

Sep 30, 2010 | 2002 Volkswagen Golf

1 Answer

Windshield Wipper switch will not turn off, 2005 Trailblazer

There was a recall on the wiper circuit board cracking and causing the problems your having and at worst the wipers not working. For now you can pull the fuse to the wipers to save the wiper blades, but the problem is the circuit board where the wire harness clips on to the wiper motor cracks and will need to be re-soldered. You can check with the dealer to see if your wiper motor is still covered with the campaign a few years ago, if not you can buy the replacement circuit board at most larger auto parts store like Auto Zone and they can give you the step by step instructions to get the job done. A light tap to the electric motor where the wire harness will also fix this problem, but it really needs to be re-soldered or replaced. Good luck

Dec 10, 2009 | 2005 Chevrolet TrailBlazer

1 Answer


merci sounds like its in the steering colum take the outside covers off and take a peak

Feb 13, 2009 | 2001 Hyundai Elantra

2 Answers


the relay is normally in the wiper motor itself go to a salvage yard and if you change it test it with the plugs before putting back together because if there is no change the problem could be in the switch

Jan 25, 2009 | 1987 Ford Escort

1 Answer

Dodge Avenger 2008 signal lights and windshield wippers

short in the relay or the relay itself is bad and it is short circuiting the computer.

Dec 22, 2008 | 1998 Dodge Avenger

Not finding what you are looking for?
1995 Volkswagen Jetta Logo

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

78267 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides