Shifts fine on cold start or after you stop and turn it off, or until you get over 50 mph then when you stop it shifts hard 1st thru 3rd gears and cant tell if it shifts into 4th or OD
SOURCE: factory controlled transmission
sounds like a sticking valvebody issue , try a service flush with preformance additive from BG ...I would also drop pan inspect for any debris and change filter and replace fluids, test run... please rate my help...
SOURCE: 95 GMC Sierra 4L60E will not shift down to 1st or up to 4th.
no power stuck in 3rd gear electric shop unless youve burnt it up good luck...www.TransmissionGarage.com
SOURCE: Hesitation shifting between 3rd and 4th gears
yes i have heard of this and my friend is on the second transmission in his 2006 2500HD.the first time there was internal issues and the second time they ended up changing out the whole tranny.
SOURCE: 4l60e no forward or reverse gears operating
It sounds like your torque converter or the pump is broken.
SOURCE: 03 yukon with 125000 miles wont shift into 3rd
yes but you can get it less becauses the kit cost only 72 to220$ for it and its a half day labor onit any ? you can call 863 261 6116 if no answer leave a message
Its
cold start issues:----
Go
through the list of help links mentioned below:----
Click
the link :----
Cold start problem and vehicle shudder around 2500 to
3500 rpms
----------
http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html
--------------
http://technoanswers.blogspot.in/2012/02/ford-explorer-40-will-not-idle-when.html
--------
http://technoanswers.blogspot.com/2012/01/automatic-transmission-shift-lever-hard.html
----------
http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-when-cold.html
-----------
These
will help.
Thanks.
Cold start problem and vehicle shudder around 2500 to
3500 rpms
----------
1,578 views
Usually answered in minutes!
already changed filter and fluid.
×