Question about Cars & Trucks

1 Answer

What is this sensor called ? - Cars & Trucks

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 8 Answers

It is possibly the intake air temperature sensor.

Posted on Nov 30, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the speed sensor?

there several speed sensors 1 on every wheel for abs called wheel speed sensor and in transfer case 4wd or awd call output shaft speed sensor or vehicle speed sensor and input shaft speed sensor which can be a computer generated signal from crankshaft sensor and output shaft speed sensor this is to determine torque converter lock up.

May 16, 2014 | 2004 Jeep Grand Cherokee

1 Answer

Cant find base1 sensor2 on a 96 ford explorer 6 cylinder 4 wheel drive

It's called bank, not base. On a v6 or v8, each side of the engine is called a bank. Bank 1 is always the side where the number 1 cylinder is located. On Fords, number 1 is on the right bank or side, the right as if you were sitting in the vehicle, so well, the passenger side.
Sensor 2 is the oxygen sensor in the exhaust stream after the catalytic converter (somebody recently called it the cadillac converter!). You have two oxygen sensors on the right bank, one before the cat and sensor 2 is after the cat. The only purpose of sensor 2 is so the computer can monitor the efficiency of the catalytic converter. It compares the readings from sensor 1 and sensor 2. Sensor 1 information is how the computer adjusts fuel trim.

Sep 27, 2013 | 1996 Ford Explorer

1 Answer

Where is the 02 sensor on a2002 lincoln continnetal

There are four sensors on the Continental cat converter. Because it is front wheel drive, the engine is rotated 90 degrees compared to a rear wheel drive. Next up is location. Front O2 sensor should be near the radiator.It will have a green connector where it is plugged into wire harness. It is called left sensor on the frt wheel drive cars. The right hand O2 sensor is downstream on the inlet pipe right above number 2 cat, the one that looks like a catchers mit, ahead of the flex pipe.Sensor 1 reads air/fuel mixture and is commonly called O2 sensor 1. remember green connector. Sensor 2 monitors the function of your catalytic converter and have a blue connector plug. Front wheel drive cars are a bit tougher because everything is 90 degrees off of diagnosis, front,rear, number 1,number 2. BTW, the sensors with blue connectors are called CMS sensors for catalytic monitor system and rarely go bad. Auto Zone scans for free and I would have it scanned before popping 40 bucks for new.

Apr 04, 2013 | 2002 Lincoln LS

1 Answer

Where is p1148 sersor loced at on nissan armada 2004

P1148 closed loop control,, this means the computer does not see closed loop , the problem could be a bad air fuel sensor also called oxygen sensor this is the top one before the converter, check the wiring to sensor and connection if that is good then replace the sensor, this sensor on this nissan is called an air /fuel sensor and are costly. good day

Oct 29, 2012 | 2004 Nissan Armada

1 Answer

My Nissan Murano 2004 is getting trouble code p1273

that is a code for the A/F sensor. that is a air/fuel ratio sensor aka front 02 sensor. used to be called front 02 sensor, but nowadays they call them A/F sensor.

Apr 19, 2011 | 2004 Nissan Murano

1 Answer

I need to locate the vehicle speed sensor on 2006 4 cylinder Nissan ALtima

if its a po725 code its engine speed fault ,replace crank sensor.for vehicle speed there are two identical sensors near each other on called revolution sensor other is called turbine speed sensor.

Feb 05, 2011 | 2006 Nissan Altima

1 Answer

Camshaft positioning sensor

The cam sensor should be in the distributer, not in the cap. They used to call them pickup coils, but now they call them Cam sensors.

Aug 27, 2008 | 2000 Dodge Durango

1 Answer

How many air/fuel or oxygen sensors are on the 2002 Prerunner 4cylinder?

The air-fuel sensor is located BELOW the manifold, on the side of the head pipe. You would need to be under the vehicle to see it.
That sensor is commonly called "bank one/sensor one".

Jun 07, 2008 | 2002 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14264 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides